Craftsman 917.273062 owner manual Battery, Other, Fuel System, Engine OIL, Cylinders

Page 32

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

_lb CAUTION: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter

storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this

manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Mainte- nance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage; battery

may require recharging.

=To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected

and battery cleaned thoroughly (see

"TO CLEAN BATTERY AND TERMI- NALS" in the Maintenance section of this manual).

°After cleaning, leave cables discon- nected and place cables where they

cannot come in contact with battery terminals.

°If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposites from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage.

Also, experiance indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of and engine while in storage.

1.Drain the fuel tank.

2.Start the engine and let it run until the fuel lines and carburetor are empty.

°Never use engine or carburetor cleaner products in the fuel tank or permanent

damage may occur.

° Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run

engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach

the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to "START" position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

°If possible, store your tractor indoors

and cover it to give protection from dust and dirt.

o Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows conden-

sation to form and will cause your tractor to rust.

IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Icraftsmani Limitedtwo Yearwarranty on Craftsman Riding Equipm ENT Parts Limited 90 DAY Warranty on BatteryDo not General OperationI1.SLOPE Operation Ill. Children Page Customer Responsibilities Product SpecificationsRepair Agreement Seat Unpack Carton Tools Required for AssemblyTo Remove Tractor from HOW to SET UP Your Tractor Check BatteryInstall Seat Before Removing Tractor from SkidPage Install Mower and Drive Belt Checklist Checktire PressureCheck Mower Levelness Check for Proper Position ALL BeltsClutch Disengaged Know Your Tractor To Move Forward Backward HOW to USE Your TractorTo SET Parking Brake To Operate on Hills To Adjust Gauge WheelsTo Operate Mower Before Starting the Engine MentsPurge Transmission To Start EngineAutomatic Transmission Warm UP Mowing Tips Before Each USE Lubrication ChartGeneral Recommendations Blade Removal BatteryOperator Presence System Engine LubricationClean AIR Screen CleaningEngine OIL Filter MufflerTo Install Mower To Level Mower HousingSIDE-TO-SIDE Adjustment To Remove MowerMower Drive Belt Removal Mower Drive Belt InstallationTo Replace Mower Drive Belt To Replace Mower Drive Belt To Adjust Attachment ClutchTo Replace Mower Blade Drive Belt Belt Removal To Adjust BrakeBelt Installation To Adjust Motion Control Lever To Adjust Steering Wheel AlignmentFront Wheel TOE-INADJUSTMENT Transmission REMOVAL/REPLACE- MentTo Remove Wheel for Repairs To Start Engine with a Weak BatteryReplacing Battery To Remove Hood and Grill AS Sembly To Adjust Attachment Lift SpringTo Replace Headlight Bulb To Adjust Choke Control To Adjust CarburetorPreliminary Setting Final SettingBattery OtherFuel System Engine OILProblem Cause CorrectionTroubleshooting Problem ChartTroubleshooting Chart Cause CorrectionFast SlowPage Schematic Tractor Model Number 917,273062 ELECTa£CkuzcHTractor -- Model Number Electrical Tractor --MODEL Number Electrical KEY Part DescriptionTractor Model Number 917.273062 Chassis and Enclosures Tractor --MODEL Number Chassis and Enclosures DescriptionTractor Model Number Ground Drive Tractor --MODEL Number Ground Drive UNCTractor Model Number Steering Tractor -- Model Number SteeringTractor Model Number Engine Spark Arrester KITEngine KEY PartTractor --MODEL Number Seat Assembly KEY Part NO. NO. DescriptionDecals Tractor Model NumberWheels and Tires Tractor -- Model Number Lift Assembly KEY Part NO. NO,DESCRIPTION Tractor Model Number Mower Deck Tractor --MODEL Number Mower Deck KEY Part NO. NO.DESCRIPTION111 Tractor --MODEL Number TRANSAXLE--MODEL Number 222-3010L KEY Part Description144569 Shaft Pump 127148X Swashplate Ylinder HEAD, Valve and Breatherj IGNITION/ELECTRICALJ Blower Housing and Bafflesj Tractor =-MODEL Number Exhaustj HEAD/VALVE/BREATHER Crankcase KEY Part Tractor --MODEL NUM BER Kohler ENGINE-MODEL Number CV20S, Type NumberTRACTOR-- Model NUM BER KEY Part NO. NO.DESCRIPTIONKohler ENGINE-MODEL Number CV20S, Type Number Page Page Suggested Guide for Sighting Slopes for Safe Operation Get it fixed, at your home or ours

917.273062 specifications

The Craftsman 917.273062 is a high-performance riding lawn mower designed for residential and light commercial use, blending efficiency, power, and ease of operation. This robust machine is ideal for users seeking to maintain larger lawns or properties with varying terrains.

One of the standout features of the Craftsman 917.273062 is its powerful engine. Equipped with a 19.5 horsepower Briggs & Stratton engine, this mower delivers reliable performance, offering ample power to handle thick grass and uneven surfaces. The engine's design ensures smooth operation with reduced noise levels, making mowing more pleasant.

The mower features a 42-inch cutting deck, allowing it to cover vast areas in a single pass. This deck design incorporates a twin-blade system, which enhances cutting efficiency and provides a clean, even cut. The adjustable cutting heights, ranging from 1.5 inches to 4 inches, allow users to customize their mowing experience based on their lawn's specific needs.

For improved maneuverability, the Craftsman 917.273062 features a tight turning radius, enabling users to navigate around obstacles such as trees, flower beds, and garden fixtures with ease. This is particularly advantageous for homeowners with intricate landscapes. The riding mower is also designed with a comfortable, high-back seat, which is ergonomically shaped to provide support and reduce fatigue during prolonged use.

Technologically, the mower includes a user-friendly dashboard that displays essential information, such as fuel level, speed settings, and maintenance reminders. This intuitive interface simplifies operation and helps users manage their mowing tasks effectively.

Another characteristic of the Craftsman 917.273062 is its ease of maintenance. The mower features an accessible cutting deck that makes it simple to clean and maintain the blades, ensuring optimal performance over time. Additionally, the mower is equipped with a fuel-efficient system, reducing the frequency of refueling and minimizing environmental impact.

In summary, the Craftsman 917.273062 combines power, efficiency, and user-friendly design to provide a superior mowing experience. Its combination of a robust engine, versatile cutting deck, ergonomic design, and ease of maintenance makes it a preferred choice for homeowners and landscape enthusiasts alike. Whether for routine lawn care or tackling overgrown areas, the Craftsman 917.273062 proves to be a reliable and effective solution.
Top Page Image Contents