Craftsman 917.27499 manual Tractor, Engine Fuelsystem, Engineoil, Cylinders, Other

Page 29

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

_kCAUTION: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Anow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for

aperiod of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this

manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Mainte- nance section of this manual

4.Be sure that aU nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting,

BATTERY

*Fully charge the battery for storage.

*After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see "TO CLEAN BA']_ERY AND TERMI- NALS" in the Maintenance section of this manual).

After cleaning, leave cables discon- nected and place cables where they

cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUELSYSTEM

IMPORTANT: It is importantto prevent

gum deposttes from forming in essential fuel system parts such as carburetor, fuel

hose, or tank during storage. Also,

experiance indicates that alcohol blended fuels (caned gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of and engine while in storage.

1.Drain the fuel tank.

2.Start the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container, Run

engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach

the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINEOIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER(S)

1, Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to =START" position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows conden-

sation to form and wil( cause your tractor to rust.

IMPORTANT: Never cover trector while engine and exhaust areas are still warm.

29

Image 29
Contents Icraftsmawi Limited 90 DAY Warranty on Battery II. Slope Operation General OperationWhile on the slope Follow the manufacturersrecommenda Stabilityof the machineMachine. Tall grass can hide obstacles IV. ServiceNl. Children Tragic accidents can occur if the operator Wash hands after handling Safety is InvolvedRC12YC Ground Speed Product Specifications Gasoline 3.5 GallonsReverse FrontMower SeatHOW to SET UP Your Tractor Tools Required for AssemblyTo Remove Tractor from Carton Unpack Carton Before Removing Tractor from SkidPacking and set aside for assembly of seat to tractor Install SeatAdjust seat before tightening adjustment knob Mower suspension Install Mower and Drive BeltCheck Tire Pressure Shoder Bolt WheelCheck Mower Levelness ChecklistFor best cutting results, mower should be Check for Proper Position of ALL BeltsAttachment Reverse Neutral Highlow Clutch Engaged NEOENG. ...OFFO,L.RESSUeLIG..SOO%..P TKnowyour Tractor Our tractors conform to the safety standardsStopping HOW to Useyourtractor To SET Parking BrakeTo USE Choke Control To Move Forward and BACK- WardTo Operate Mower To Adjust Gauge WheelsTo Operate on Hills To TransportMents Towing Carts and Other AI-rACHBefore Starting the Engine Check Engine OIL Level ADD Gasoline= Always operate engine at full throttle Mowing TipsBefore Each USE Lubrication ChartGeneral Recommendations Brake Operation BatteryTires Operator Presence SystemEngine Lubrication BeltsCheck Transaxle OIL Level Clean AIR INTAKE/COOLING Areas Clean AIR ScreenTo Service PRE.CLEANER CleaningTo Level Mower Housing To Install MowerSIDE-TO-SIDE Adjustment TractorMower Drive Belt Installation Recheck side-to-side adjustmentBoth Front Links Must be Equal Length Mower Drive Belt RemovalTo Replace Mower Blade Drive Belt Install Mower and DriveTo Adjust Brake To Adjust Steering Wheel ALIGN- Ment Belt InstallationSears or other qualified service center DePulle KeeperReplacing BAI-IERY To Remove Wheel for Repairs Front WheelRear Wheel Interlocks and Relays To Replace Headlight BulbTo Replace Fuse To Remove Hood and Grill AS SemblyTo Adjust Carburetor To Adjust Choke ControlFinal Setiing Acceleration TestEngine Fuelsystem TractorEngineoil CylindersCause Correction ProblemCause Troubleshooting ChartTurn switch on Mower drive belt worn Blades improperly installedLight switch Check wiring and connecTtAGTOP.oDEL HU6-P9Lt,14990 Electrical Tractor - Model NumberKEY Part NO, no Description Tractor - Model NUM BERTRACTOR--MODELNUMBER917.274990 Chassisandenclosures KEY Part Description TRACTOR- -MODEL Number Chassis and EnclosuresKEY Part NO. no TRACTOR- Model Numb ER Ground Drive KEY Part Description TRACTOR- Model NUM BER Ground DriveTRACTOR- Model Numb ER Steeringassembly TRACTOR- Model NUM BER Steeringassembly Spark Arrester KIT Tractor - Model Numb ER 917,274990 KEY Part NO. NO.DESCRIPTION TRACTOR- Model Numb ER Seat AssemblyDecals TRACTOR-- Model NumberWheels & Tires IEY Part DescriptionLift Assembly KEY Part TRACTOR- Model Number Lift AssemblyTransaxle 42GOR Nut 3/8-24Cylinder HEAD, Valve and Breather Crankcase HEAD/VALVE/BREATHERPage IGNITION/CHARGING KEY Part NO. NO.DESCRIPTION Blower Housing & BafflesStarting System OIL PAN/LUB Rication KEY Part Description Starting SystemCranksha Fuel System KEY Part NO. no TRACTOR- Model NumberPage Suggested Guide for Sighting Slopes for Safe Operation 179079 04.09.01 RH 1X-5,33-6937

917.27499 specifications

The Craftsman 917.27499 is a versatile and powerful riding lawn mower designed to provide optimum cutting performance and enhance the overall mowing experience. Known for its robust construction and innovative features, this mower is ideal for homeowners with medium to large yards, ensuring efficient grass management with ease.

One of the main features of the Craftsman 917.27499 is its reliable 19 horsepower Briggs & Stratton engine. This powerful engine offers ample torque and speed, enabling the mower to tackle thick grasses and uneven terrains with relative ease. The mower's automatic transmission allows for smooth acceleration and deceleration without the need for manual gear shifting, providing a user-friendly operation.

The cutting deck of the Craftsman 917.27499 is another standout feature. With a 42-inch cutting width, it allows for quick and efficient mowing, reducing the number of passes needed to cover large areas. The deck is made from durable steel to withstand the rigors of regular use, and it offers three adjustable cutting heights, enabling users to customize the mowing experience according to the grass type and height.

Ergonomics also play a significant role in the design of this mower. The comfortable, adjustable seat ensures that users can have an optimal riding position, reducing fatigue during lengthy mowing sessions. Additionally, the steering wheel is designed for ease of handling, providing accurate control and maneuverability in tight spaces around obstacles like trees and flower beds.

Another remarkable aspect of the Craftsman 917.27499 is its enhanced technology features. It includes an easy-to-use control panel that allows users to manage the mower’s functions seamlessly. Furthermore, the mower's maintenance features, such as the quick-change blade system, facilitate easy blade replacement, promoting consistent cutting performance.

Safety is paramount with the Craftsman brand, and the 917.27499 includes several safety features. The mower is equipped with a safety switch that automatically shuts off the engine if the operator leaves the seat, preventing any accidents during operation.

In summary, the Craftsman 917.27499 is a powerful, reliable, and user-friendly riding lawn mower that combines advanced technologies with robust performance. Its key features, ergonomic design, and safety mechanisms make it an excellent option for homeowners seeking efficiency and ease of use in lawn care. Whether navigating tight corners or managing larger expanses of grass, the Craftsman 917.27499 excels in delivering a well-manicured lawn with minimal effort.