Craftsman 917.28948 Before Starting the Engine Check Engine OIL Level, To Start Engine

Page 18

SERVICE REMINDER/HOUR METER Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs ser-

vicing. When service is required, the service reminder will flash for two hours. To service

engine and mower, see the Maintenance section of this manual.

NOTE: Service reminder runs when the ignition key is in any position but "STOP".

For acurate reading, be sure key remains in the "STOP" position when engtne is not running.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in yourtractor has been shipped, from the factory, already filled with summer weight oil.

!.Check engine oil with tractor on level

groun&

2.Unthread and remove oil fill cap/dipstick; wipe oil off° Reinsert the dipstick into the tube and rest oil fill cap on the tube. Do not thread the cap onto the tuber Remove and read oil level, if necessary, add oil until "FULI_ mark on dipstick is reached. Do not overfill.

3.For cold weather operation you should change oil for easier starting (See the oil viscosity chart in the Maintenance section of this manual).

4.To change engine oil, seethe Maintenance section in this manual.

5.Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of

87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil

with gasoline. Purchase fuel in quanti- ties that can be used within 30 days to

u_elaSsure fuel freshness.

CAUTION: Wipe off any spilled oil or

. Do not store, spill or use gasoline near an open flame.

IMPORTANT: When operating in temper- atures below 32°F(0°C), use fresh, clean winter grade gasoline to help ensure good cold weather starting.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage° To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Usefresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

RESERVE FUEL VALVE OPERATION 1_ Raise seat to access reserve fuel

valve,

2, In normal operation, valve should be set to primary (as shown in view)

3.If tractor runs out of fuel, rotate valve

handle to reserve.

4o Drive tractor to be refueled.

5.After refueling, return valve to primary position.

Reserve

Fuel Valve

@

Primary

TO START ENGINE

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

1.Be sure freewheel control is in the trans- mission engaged position.

2.Sit on seat in operating position, depress

brake pedal and set parking brake.

3o Move attachment clutch to disengaged position.

4.Move throttle control to fast position

5.Pull choke control out for a cold engine

start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below_

18

Image 18
Contents GAR E Tracto Craftsman Full Warranty TWO Years on Riding Equipment Sears, Roebuck and Co., Hoffman Estates, ILAfter handling General Operation Service Safe Handling of GasolineGeneral Service Customer Responsibilities Product SpecificationsGasoline Capacity Gallons Repair Protection1Wheel Unpack Carton Tools Required for AssemblyTo Remove Tractor from Operation section for locationAttachment lift lever LeverSlide mower under tractor Attach mower side suspension arms To chassisAttach rear lift links C Install Belt On Engine Clutch Pulley M Attach front link ECheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake System@@@@ IPmHIKnow Your Tractor Attachment Clutch SwitchService Reminder / Hour Meter Reverse Operation SystemHOW to USE TractorTo USE Choke Control N To Adjust Mower Cutting Height To Move Forward and BackwardTo Operate Mower To Stop Mower Blades MentsBefore Starting the Engine Check Engine OIL Level To Start EngineAutomatic Transmission Warm UP Purge TransmissionMowing TiPS Sso MaintenanceSchedule StorageBattery Lubrication To Change Engine OILAIR Filter MufflerCleaning UtionDeck Washout Port To Install Mower To Remove MowerFRONT-TO-BACK Adjustment Visual SIDE-TO-SIDE AdjustmentPrecision SIDE-TO-SIDE Adjustment To LEVEL. MowerTo Replace Mower Drive Belt To Remove Wheel for Repairs To Check BrakeFront Wheel TOE-IN/CAMBER To Start Engine with a Weak BAT- TeryEngine To Adjust Throttle Control Cable MentCylinders Engine Fuel SystemEngine OIL OtherCORRECTI!ON ProblemCause Hard to start Engine will not turn overCorrection Excessive VibrationPoor cut uneven 1 cutting ProblemBlades improperly installed Poor grass discharge Headlights not working If so equippedCorrection Battery will not charge Loss of driveEngine OFF Engine dies when tractor is shifted into reverse Purge transmissionSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across HillGarantia Completa DE Craftsman DOS AI,IOS Para EL Equipo TractorFuncionamiento General IV. Remolque Page U1R Especificaciones DEL ProductoAMP/HR MIN CCA Acuerdo DE RepuestoLlaves Tubo de desagLieVerifique LA Bateria Herramientas Necesarias ParaEL Montaje 1NSTALE LA SegadoraUbique LA Cortadora DE Cesped EN SU Lugar SI LA TIENE, Instale LA Barra Antibalanceo S EN EL ChasisInstale LA Correa EN LA Polea DEL Embrague DEL Motor M Instale EL Eslabon Delantero EReemplazar LA Correa DE LA Cuchilla Revision DE LA Presion DE LAS Llantas Revision DE LA Nivelacion DEL CON JuntoFuego lndica un peligro que, si no se evita, puede Palanca DE Mando Crucero Familiaricese CON SU TractorSU Tractor Pedal DE Marcha AdelantePara Usar EL Control DE LA Aceler Parada Cuchillas DE LA SegadoraMotor Impulsion DE RecorridoUtilizar EL Mando Crucero DorasTransmisibn Desenganchada AccesoriosMECA,NISMO DE Aviso DE Servicio / Cronometro Lina DE ReservaArranque CON Tiempo Templado 50F/10C Y MAS AutomaticaConsejos Para Segar Mantenimiento CADAuseFuncionamiento ATR,&S ROS Operacion DEL FrenoLlantas Cuidado DE LA CuchillaNivel DEL Fluido DE LA Bomba DEL Transeje NalesEnfriamiento DEL Transeje CorreasBUJiAS DE EnfriamentoSilenciador Filtro DE Combustible EN LineaLimpieza Puerto DE Lavado DE LA CubiertaPara Instalar LA Segadora CIO O DE Hacer AjustesPara Desmontar LA Cortadora DE Instalar LA Segadora Y LA Correa DERegulacion DE LA Precision DE Lado Para Nivelar LA SegadoraRegulacion Visual DE Lado a Lado Ajuste DE Delante a ATR,,SDE Movimiento Para Reemplazar LA Correa DE LA Cuchilla DE LA SegadoraPara Cambiar LA Correa DE Impulsion Desmontaje DE LA CorreaDelanteras Control DEL FrenoIMPRESlON / Inclinacin DE LAS Ruedas Para Remover LAS Ruedas Para Hacer ReparacionesPara Remover EL Conjunto DEL Capo ¥ DEL Enrejado Reemplazar LA BateriaPara Cambiar EL Fusible Para Cambiar LA Bombilla DE LA LUZ DelanteraAceite DEL Motor MotorSistema DE Combustible OtrosIdentificacion DE Problemas Prdida de 9. fuerza Sigue SearsPrdida de As cuchii* las segado- ras no rotanNando La bateria no carga Prdida de Impulsi6n Mala des- carga de! cspedLas luz cos Purgue la transmisi6nPage Operacion Segura Your Home Sears Parts and Repair CenterCanada