Craftsman 917.28948 Tools Required for Assembly, To Remove Tractor from, Unpack Carton

Page 8

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely, Use the correct tools as necessary to ensure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set wilt make assembly easier. Standard wrench sizes are listed.

(2)

7/16"

wrenches

Utility

knife

(1)

t/2"

wrench

Tire

pressure gauge

(I)

3/4"

wrench

Pliers

(1)

3/4"

socket w/ddve

ratchet

When right or left hand is mentioned in this manual, it meanswhen you are in the operating position (seated behind the steering wheel).

ADJUST SEAT 1. Sit in seal

2, Lift up adjustment lever (A) and slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

3.Release lever to lock seat in position.

TO REMOVE TRACTOR FROM

CARTON

UNPACK CARTON

,Remove all accessible loose parts and

parts cartons from carton,

Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.

Remove mower and packing materials,

Check for any additional loose parts or cartons and remove.

BEFORE REMOVING TRACTOR FROM SKID

TO CHECK BATTERY

1, Lift hood to raised position.

NOTE: if this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at 6-10 amps, (See

"BATTERY" in Maintenance section of this manual for charging instructions).

Forbatteryandbatterycableinstallationsee "REPLACING BATTERY" in the "Service

and Ad ustments" section in this manual.

NOTE: You may now roll your tractor offthe skid, Follow the appropriate instruction below to remove the tractor from the skid.

WARNING: Before starting, read, un- derstand and follow all instructions in the

Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other

people and objects.

TO ROLL TRACTOR OFF SKID (See

Operation section for location and

function of controls)

1_ Raise attachment lift lever to its highest position,

2.Release parking brake by depressing

brake pedal

3, Place freewheel control in disengaged position to disengage transmission (See "TO TRANSPORT" inthe Operation sec-

tion of this manual).

4, Roll tractor forward off ski&

8

Image 8
Contents GAR E Tracto Craftsman Full Warranty TWO Years on Riding Equipment Sears, Roebuck and Co., Hoffman Estates, ILAfter handling General Operation Service Safe Handling of GasolineGeneral Service Product Specifications Gasoline Capacity GallonsCustomer Responsibilities Repair Protection1Wheel Tools Required for Assembly To Remove Tractor fromUnpack Carton Operation section for locationAttachment lift lever LeverAttach rear lift links C Slide mower under tractorAttach mower side suspension arms To chassis Install Belt On Engine Clutch Pulley M Attach front link ECheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake System@@@@ IPmHIAttachment Clutch Switch Service Reminder / Hour MeterKnow Your Tractor Reverse Operation SystemTo USE Choke Control N HOW to USETractor To Operate Mower To Adjust Mower Cutting HeightTo Move Forward and Backward To Stop Mower Blades MentsBefore Starting the Engine Check Engine OIL Level To Start EngineAutomatic Transmission Warm UP Purge TransmissionMowing TiPS Maintenance ScheduleSso StorageBattery Lubrication To Change Engine OILAIR Filter MufflerDeck Washout Port CleaningUtion To Install Mower To Remove MowerVisual SIDE-TO-SIDE Adjustment Precision SIDE-TO-SIDE AdjustmentFRONT-TO-BACK Adjustment To LEVEL. MowerTo Replace Mower Drive Belt To Check Brake Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs To Start Engine with a Weak BAT- TeryEngine To Adjust Throttle Control Cable MentEngine Fuel System Engine OILCylinders OtherProblem CauseCORRECTI!ON Hard to start Engine will not turn overCorrection Excessive VibrationProblem Blades improperly installedPoor cut uneven 1 cutting Poor grass discharge Headlights not working If so equippedBattery will not charge Loss of drive Engine OFF Engine dies when tractor is shifted into reverseCorrection Purge transmissionSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across HillGarantia Completa DE Craftsman DOS AI,IOS Para EL Equipo TractorFuncionamiento General IV. Remolque Page Especificaciones DEL Producto AMP/HR MIN CCAU1R Acuerdo DE RepuestoLlaves Tubo de desagLieHerramientas Necesarias Para EL MontajeVerifique LA Bateria 1NSTALE LA SegadoraUbique LA Cortadora DE Cesped EN SU Lugar SI LA TIENE, Instale LA Barra Antibalanceo S EN EL ChasisReemplazar LA Correa DE LA Cuchilla Instale LA Correa EN LA Polea DEL Embrague DEL Motor MInstale EL Eslabon Delantero E Revision DE LA Presion DE LAS Llantas Revision DE LA Nivelacion DEL CON JuntoFuego lndica un peligro que, si no se evita, puede Familiaricese CON SU Tractor SU TractorPalanca DE Mando Crucero Pedal DE Marcha AdelanteParada Cuchillas DE LA Segadora MotorPara Usar EL Control DE LA Aceler Impulsion DE RecorridoUtilizar EL Mando Crucero DorasTransmisibn Desenganchada AccesoriosMECA,NISMO DE Aviso DE Servicio / Cronometro Lina DE ReservaArranque CON Tiempo Templado 50F/10C Y MAS AutomaticaConsejos Para Segar Mantenimiento CADAuseOperacion DEL Freno LlantasFuncionamiento ATR,&S ROS Cuidado DE LA CuchillaNales Enfriamiento DEL TransejeNivel DEL Fluido DE LA Bomba DEL Transeje CorreasDE Enfriamento SilenciadorBUJiAS Filtro DE Combustible EN LineaLimpieza Puerto DE Lavado DE LA CubiertaCIO O DE Hacer Ajustes Para Desmontar LA Cortadora DEPara Instalar LA Segadora Instalar LA Segadora Y LA Correa DEPara Nivelar LA Segadora Regulacion Visual DE Lado a LadoRegulacion DE LA Precision DE Lado Ajuste DE Delante a ATR,,SPara Reemplazar LA Correa DE LA Cuchilla DE LA Segadora Para Cambiar LA Correa DE ImpulsionDE Movimiento Desmontaje DE LA CorreaControl DEL Freno IMPRESlON / Inclinacin DE LAS RuedasDelanteras Para Remover LAS Ruedas Para Hacer ReparacionesReemplazar LA Bateria Para Cambiar EL FusiblePara Remover EL Conjunto DEL Capo ¥ DEL Enrejado Para Cambiar LA Bombilla DE LA LUZ DelanteraMotor Sistema DE CombustibleAceite DEL Motor OtrosIdentificacion DE Problemas Sears Prdida dePrdida de 9. fuerza Sigue As cuchii* las segado- ras no rotanMala des- carga de! csped Las luz cosNando La bateria no carga Prdida de Impulsi6n Purgue la transmisi6nPage Operacion Segura Canada Your HomeSears Parts and Repair Center