Craftsman 917.28948 owner manual AIR Filter, Muffler

Page 24

AIR FILTER

Your engine will not run properly using a dirty air filter. Service paper cartridge ever,/ two months or every 25 hours of operation, whichever occurs first.

Service paper cartridge more often under dusty conditions°

Replace the paper cartridge ann ually, or after ever,/100 hours of operation°

TO SERVICE CARTRIDGE

, Replace a dirty, bent, or damaged car_ tridge, Handle new cartridge carefully; do not use if the rubber seal is damaged.

NOTE: Do not wash the paper cartridge or use pressurized air, as this will damage the cartridge.

1.Open door (A) on the blower housing to access the air cleaner element (B).

2.Unhook the latch (C) and remove the element°

3.Gently tap the paper element to dislodge dirt.

4.Clean all air cleaner components of any

accumulated dirt or foreign material. Prevent any dirt from entering the throat of carburetor.

5.Install cleaned or new element on the base and secure with latch.

6.Close and latch the door.

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating_ Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.

CLEAN AIR INTAKE/COOLING AREAS

To ensure proper cooling, make sure the grass screen, cooling fins, and other exter-

nal surfaces of the engine are kept clean at all times.

Every !00 hours of operation (more often under extremely dusty, dirty conditions), remove the blower housing and other cooling shrouds_ Clean the cooling fins and external

surfaces as necessary. Make su re the cooling shrouds are reinstalled.

NOTE: Operatingthe engine with a blocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds removed will cause engine damage due to overheating.

MUFFLER

Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or damage.

SPARK PLUG(S)

Replace spark plug(s) at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first.

Spark plug type and gap setting are shown

in "PRODUCT SPECIFICATIONS" section of this manual

IN-LINE FUEL FILTER

The fuel filter should be replaced once each season. If fuel filter becomes clogged, ob- structing fuel flow to carbureto r, replacement is required.

1.With engine cool, remove filter and plug fuel line sections.

2.Place new fuel filter in position in fuel line with arrow pointing towards carburetor.

3.Be sure there are no fuel line leaks and clamps are properly positioned.

4.immediatelywipe up anyspilled gasoline.

Clam_amp

Fuel Filter ------4-_j/rJ_J

24

Image 24
Contents GAR E Tracto Craftsman Full Warranty TWO Years on Riding Equipment Sears, Roebuck and Co., Hoffman Estates, ILAfter handling General Operation Service Safe Handling of GasolineGeneral Service Product Specifications Gasoline Capacity GallonsCustomer Responsibilities Repair Protection1Wheel Tools Required for Assembly To Remove Tractor fromUnpack Carton Operation section for locationAttachment lift lever LeverSlide mower under tractor Attach mower side suspension arms To chassisAttach rear lift links C Install Belt On Engine Clutch Pulley M Attach front link ECheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake System@@@@ IPmHIAttachment Clutch Switch Service Reminder / Hour MeterKnow Your Tractor Reverse Operation SystemHOW to USE TractorTo USE Choke Control N To Adjust Mower Cutting Height To Move Forward and BackwardTo Operate Mower To Stop Mower Blades MentsBefore Starting the Engine Check Engine OIL Level To Start EngineAutomatic Transmission Warm UP Purge TransmissionMowing TiPS Maintenance ScheduleSso StorageBattery Lubrication To Change Engine OILAIR Filter MufflerCleaning UtionDeck Washout Port To Install Mower To Remove MowerVisual SIDE-TO-SIDE Adjustment Precision SIDE-TO-SIDE AdjustmentFRONT-TO-BACK Adjustment To LEVEL. MowerTo Replace Mower Drive Belt To Check Brake Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs To Start Engine with a Weak BAT- TeryEngine To Adjust Throttle Control Cable MentEngine Fuel System Engine OILCylinders OtherProblem CauseCORRECTI!ON Hard to start Engine will not turn overCorrection Excessive VibrationProblem Blades improperly installedPoor cut uneven 1 cutting Poor grass discharge Headlights not working If so equippedBattery will not charge Loss of drive Engine OFF Engine dies when tractor is shifted into reverseCorrection Purge transmissionSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across HillGarantia Completa DE Craftsman DOS AI,IOS Para EL Equipo TractorFuncionamiento General IV. Remolque Page Especificaciones DEL Producto AMP/HR MIN CCAU1R Acuerdo DE RepuestoLlaves Tubo de desagLieHerramientas Necesarias Para EL MontajeVerifique LA Bateria 1NSTALE LA SegadoraUbique LA Cortadora DE Cesped EN SU Lugar SI LA TIENE, Instale LA Barra Antibalanceo S EN EL ChasisInstale LA Correa EN LA Polea DEL Embrague DEL Motor M Instale EL Eslabon Delantero EReemplazar LA Correa DE LA Cuchilla Revision DE LA Presion DE LAS Llantas Revision DE LA Nivelacion DEL CON JuntoFuego lndica un peligro que, si no se evita, puede Familiaricese CON SU Tractor SU TractorPalanca DE Mando Crucero Pedal DE Marcha AdelanteParada Cuchillas DE LA Segadora MotorPara Usar EL Control DE LA Aceler Impulsion DE RecorridoUtilizar EL Mando Crucero DorasTransmisibn Desenganchada AccesoriosMECA,NISMO DE Aviso DE Servicio / Cronometro Lina DE ReservaArranque CON Tiempo Templado 50F/10C Y MAS AutomaticaConsejos Para Segar Mantenimiento CADAuseOperacion DEL Freno LlantasFuncionamiento ATR,&S ROS Cuidado DE LA CuchillaNales Enfriamiento DEL TransejeNivel DEL Fluido DE LA Bomba DEL Transeje CorreasDE Enfriamento SilenciadorBUJiAS Filtro DE Combustible EN LineaLimpieza Puerto DE Lavado DE LA CubiertaCIO O DE Hacer Ajustes Para Desmontar LA Cortadora DEPara Instalar LA Segadora Instalar LA Segadora Y LA Correa DEPara Nivelar LA Segadora Regulacion Visual DE Lado a LadoRegulacion DE LA Precision DE Lado Ajuste DE Delante a ATR,,SPara Reemplazar LA Correa DE LA Cuchilla DE LA Segadora Para Cambiar LA Correa DE ImpulsionDE Movimiento Desmontaje DE LA CorreaControl DEL Freno IMPRESlON / Inclinacin DE LAS RuedasDelanteras Para Remover LAS Ruedas Para Hacer ReparacionesReemplazar LA Bateria Para Cambiar EL FusiblePara Remover EL Conjunto DEL Capo ¥ DEL Enrejado Para Cambiar LA Bombilla DE LA LUZ DelanteraMotor Sistema DE CombustibleAceite DEL Motor OtrosIdentificacion DE Problemas Sears Prdida dePrdida de 9. fuerza Sigue As cuchii* las segado- ras no rotanMala des- carga de! csped Las luz cosNando La bateria no carga Prdida de Impulsi6n Purgue la transmisi6nPage Operacion Segura Your Home Sears Parts and Repair CenterCanada