TO START ENGINE WITH A WEAK
BATTERY
CAUTION:
batteries. Always wear eye protection when around batteries.
If your battery is too weak to start the
engine, it should be recharged. (See
section of this manual).
if "jumper cables" are used for emer- gency starting, follow this procedure:
IMPORTANT: Your tractor is equipped
with a 12 volt negative grounded system. The other vehicle must also be a 12 volt
negative grounded system. Do not use your tractor battery to start other vehicles.
TO A'I-FACH JUMPER CABLES -
•Connect each end of the RED cable to the POSITIVE (+) terminal of each
battery, taking care not to short against chassis.
•Connect one end of the BLACK cable to the NEGATIVE
•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
•BLACK cable first from chassis and then from the fully charged battery.
•RED cable last from both batteries.
! P
'Positive" (+) | "Negative" |
|
Bolt
REPLACING BATTERY
_k CAUTION: Do not short battery
terminals by allowing a wrench or any other object to contact both terminals at
the same time. Before connecting battery, remove metal bracelets, wristwatch
bands,rings,etc.
Positive terminal must be connected first
to prevent sparking from accidental grounding.
•Lift hood to raised position.
•Remove terminal guard.
•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.
•Install new battery with terminals in same position as old battery.
•Reinstall terminal guard.
•First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.
•Connect BLACK grounding cable t
| negative | ||
| remaining hex bolt and keps nut. | ||
| Tighten | securely | • |
• | Close | terminal access | doors. |
• | Close | hood. |
|
\
Terminal | Negative (f31a, | |
Guard | Cable | |
TO REPLACE | HEADLIGHT | BULB |
•Raise hood.
•Pull bulb holder out of the hole in the backside of the grill.
•Replace bulb in holder and push bulb holder securely back into the hole in
the backside of the grill.
•C_ose hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Rep ace with 15 amp
26 behind the dash.