Weed Eater WE261 warranty Mantenimiento, Before Starting the Engine, To Start Engine

Page 13

MANTENIMIENTO

TO OPERATE ON HILLS

WARNING: Do not drive up or down hills with slopes greater than 15° and do not

• For cold weather operation you should

change oil for easier starting (See the oil

viscosity chart in the Maintenance section

!.4%3ª$%ª #!$!ª53/

# Revisar la operación del freno / Revisar la presión de las llantas

2 Revisar la presencia del operador y el !4 sistema ROS

$ Revisar que los broches no estén sueltos

/Revisar/cambiar la cuchilla de la cortadora

2 de césped

!

Limpiar la batería y las terminales

ª

$

 

%Lubricar los ejes y husos

ª # Revisar el enfriamiento del transeje

²Revisar la nivelación de la cortadora

3 de césped

0% Revisar la cinta en V

$ Aceitar las cadenas del impulsor

Revisar el nivel del aceite del motor

Revisar el aceite del motor

Limpiar la filtro de aire

Limpiar la pantalla de aire

Inspeccionar el silenciador/parachispas

Limpiar las aletas de enfriamiento del motor

Cambiar la bujía

Cambiar el cartucho de papel del filtro de aire

#!$!ª ª (/2!3

#!$!ª ª (/2!3



 





#!$!ª ª (/2!3

#!$!ª ª (/2!3





#!$!ª 4%-0/2!$!

!,-!#%.!-)%.4/

drive across any slope. Use the slope guide at the back of this manual.

Choose the slowest speed before starting up or down hills.

Avoid stopping or changing speed on hills.

If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

Move motion control lever to neutral (N) position.

To restart movement, slowly release park- ing brake and clutch/brake pedal.

Make all turns slowly.

TO TRANSPORT

When pushing or towing your riding mower, be sure to disengage transmission by placing freewheel control in freewheel position. Freewheel control is located at the rear drawbar of the riding mower.

Raise mower height adjustment to its highest position with mower height adjustment lever.

Push freewheel control down and over with foot.

of this manual).

• To change engine oil, see the Mainte-

nance section in this manual.

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the

ª#AMBIARªMÈSªAªMENUDOªCUANDOªSEªOPEREªBAJOªCARGAªPESADAªOªENªAMBIENTESªCONªALTASªTEMPERATURAS ª$ARªSERVICIOªMÈSªAªMENUDOªCUANDOªSEªOPEREªENªCONDICIONESªSUCIASªOªPOLVOROSAS

ª#AMBIARªLASªCUCHILLASªMÈSªAªMENUDOªCUANDOªSEªSIEGUEªENªSUELOªARENOSOª

fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions

RECOMENDACIONES GENERALES

La garantía para esta cortadora de césped no ampara los artículos que se han sometido al abuso o la negligencia del operador. Para recibir el valor completo de la garantía, el operador debe darle mantenimiento a la cortadora de césped conforme se indica en este manual.

Será necesario hacer algunos ajustes en forma periódica para mantener de manera correcta la cortadora de césped.

Al menos una vez cada temporada, revise si usted debe hacer algún ajuste conforme se describe en la sección de Servicio y Ajustes de este manual.

Al menos una vez al año usted deberá cambiar la bujía, limpiar o cambiar el filtro de aire y revisar si la cuchilla y la cinta están desgastadas. Una nueva bujía y un nuevo filtro de aire aseguran la mezcla adecuada de aire y combustible, lo que ayuda a que el motor funcione mejor y dure más tiempo.

ANTES DE CADA USO

1.Revise el nivel del aceite del motor.

2.Revise la operación del freno.

3.Revise la presión de las llantas.

4.Revise que los sistemas de presencia del operador y de ROS funcionen bien.

5.Revise que los broches no estén sueltos.

IMPORTANTE: No aceite ni engrase los puntos de los pivotes que tienen cojinetes de nailon especiales. Los lubricantes viscosos atraerán el polvo y la suciedad, lo que reducirá la vida de los cojinetes autolubricantes. Si siente que se deben lubricar, use sólo un lubricante tipo grafito en polvo moderadamente.

Freewheel

Control

Disengaged

Freewheel

Control

Engaged

To reengage transmission, reverse above procedure, or press brake lever all the way down.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your riding mower has been shipped from the factory already filled with summer weight oil.

1.Check engine oil with riding mower on level ground.

2.Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

1.Be sure freewheel control is in the trans- mission engaged position.

2.Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

3.Place motion control lever in neutral (N) position.

4.Move deck clutch to disengaged position.

5.Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do not run starter continuously for more than fifteen

seconds per minute.

NOTE: If at high altitude (above 3000 feet) or in cold temperature (below 32°F/0°C) the fuel mixture may need to be adjusted for best performance.

40

13

Image 13
Contents 09.08.11 CL Operator’s Manual Manual de OperarioWarranty Table of ContentsTabla DE Solución DE Problemas Safety RulesAlways wear eye protection when operat- ing machine General OperationIII. Children IV. Service Safe Handling of GasolineProduct Specifications Almacenamiento Safety RulesGeneral Service Customer ResponsibilitiesUnassembled Parts Tools Required for AssemblyTo Remove Riding Mower from Carton Unpack CartonInstall Seat HOW to SET UP Your Riding Mower Install Steering ColumnCheck Battery Slide steering shaft protective foam cover over shaftCheck Tire Pressure ChecklistCheck Deck Levelness Check for Proper Positon of Mower Drive BeltOperation Servicio Y AjustesCortadora DE Césped Retiro DE LA Cortadora DE Instalación DE LA Cortadora DE CéspedKnow Your Riding Mower To Adjust Mower Cutting Height HOW to USE Your Riding MowerTo SET Parking Brake StoppingTo Operate Mower Using the Reverse Operation SystemTo Stop Mower Blade Reverse Operation System ROSBefore Starting the Engine MantenimientoTo Start Engine Recoil Starting System Mowing TipsLeft hand side of mower should be used for trimming Sismtema DE Arranque ManualGeneral Recommendations MaintenanceBefore Each USE Brake Operation Riding MowerTires Axle and SpindlesEngine Cleaning Clean AIR ScreenAIR Filter MufflerTo Install Mower Service and AdjustmentsOperación Riding MowerSIDE-TO-SIDE Adjustment To Level Mower HousingMower Drive Belt Installation To Replace Mower Blade Drive BeltTo Adjust Brake Cómo Configurar SU Cortadora DE CéspedTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery Replacing BatteryEngine Partes no EnsambladasInterlocks and Relays To Replace FuseReglas DE Seguridad Storage BatteryEspecificaciones DEL Producto MowerProblem Cause Correction Troubleshooting ChartReglas DE Seguridad III. NiñosII. Operación EN Pendientes Operación GeneralGarantía Tabla DE ContenidoOnly Ride UP and Down HILL, not Across Hill Degrees MAX
Related manuals
Manual 20 pages 13.36 Kb Manual 40 pages 39.3 Kb

WE261 specifications

The Weed Eater WE261 is a robust and versatile string trimmer designed to tackle a variety of lawn care tasks with ease and efficiency. Aimed at both homeowners and landscaping professionals, the WE261 is built to handle the challenges of overgrown lawns and garden beds, providing powerful performance and reliability.

One of the standout features of the WE261 is its 26cc 2-cycle engine, which delivers ample power while maintaining a lightweight profile. This engine ensures that users can navigate through dense vegetation and thick weeds without compromising performance. The 2-cycle technology allows for efficient fuel usage, providing users with longer run times between refuels.

The WE261 is equipped with a dual line bump head, which automatically releases more line as needed. This feature enhances productivity by allowing the user to focus on trimming rather than manually adjusting the string. The .095-inch line diameter provides a thick cutting path, making it effective against stubborn weeds and tall grass.

Another significant characteristic of the WE261 is its ergonomic design. The trimmer features a padded hand grip and an adjustable handle, allowing users to customize their grip for maximum comfort and control. This is especially beneficial during extended use, as it minimizes fatigue and enhances maneuverability.

The trimmer also incorporates an easy-start technology, which simplifies the starting process. Users can enjoy quick and hassle-free starts with minimal effort required. This feature is particularly useful for those who may not have extensive experience with starting gas-powered equipment.

Durability is a key consideration in the design of the WE261. Constructed with high-quality materials, this weed eater is built to withstand the rigors of regular use. The robust build ensures that it can handle various outdoor conditions, making it a reliable option for any lawn care enthusiast.

In summary, the Weed Eater WE261 presents a combination of power, efficiency, and user-friendly features. With its strong 26cc engine, automatic dual line bump head, ergonomic design, and easy-start technology, it stands out as an exceptional choice for anyone looking to maintain a well-groomed lawn. Whether dealing with overgrown areas or simply keeping the yard tidy, the WE261 is up to the task, delivering performance that users can trust.