Weed Eater WE261 warranty Mowing Tips, Recoil Starting System, Sismtema DE Arranque Manual

Page 14

RECOIL STARTING SYSTEM

This unit is equipped with an engine recoil starting system. If the battery is too weak to start engine.

1.Set parking Brake.

2.Turn key to ON position.

3.Make sure unit is in neutral position.

4.Set deck to disengaged position.

5.Pull recoil cord to start engine.

Gasoline Filler

Cap

Do not mow grass when it is wet. Wet grass will plug mower and leave undesir- able clumps. Allow grass to dry before mowing.

Regulate ground speed by selecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.

When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.

SISMTEMA DE ARRANQUE MANUAL

Esta unidad está equipada con un sistema de arranque manual del motor. Si la batería está de- masiado descargada como para arrancar el motor.

1.Accione el freno de estacionamiento.

2.Gire la llave a la posición de encendido (ON).

3.Asegúrese de que la unidad está en posición neutral.

4.Coloque la plataforma en la posición desac- tivada.

5.Jale la cuerda manual para arrancar el motor.

Tapa del depósito de gasolina

No corte el césped cuando esté húmedo. El césped húmedo taponará la cortadora de césped y dejará matas indeseables. Permita que el césped se seque antes de podarlo.

Regule la velocidad terrestre al seleccionar un avance lo suficientemente lento para ajustar el desempeño de corte de la cortadora de césped así como la calidad del corte deseada.

Cuando utilice accesorios, seleccione una velocidad terrestre que se adapte al terreno y obtenga el mejor desempeño del accesorio que esté usando.

Recoil Starter

Handle

MOWING TIPS

Mower should be properly leveled for best mowing performance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual.

The left hand side of mower should be used for trimming.

Drive so that clippings are discharged onto the area that has already been cut. Have the cut area to the right of the riding mower. This will result in a more even distribution of clippings and more uniform cutting.

When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until finished.

If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clippings. Make first cut relatively high; the second to the desired height.

Manija de arranque manual

CONSEJOS PARA CORTAR EL CÉSPED

La cortadora de césped debe estar bien ni- velada para que su desempeño sea el mejor. Consulte la parte de “NIVELACIÓN DE LA CAR- CASA DE LA CORTADORA DE CÉSPED” en la sección de Servicio y Ajustes de este manual.

El lado izquierdo de la cortadora de césped se debe usar para podar.

Conduzca de manera que los recortes de des- carguen sobre el área que ya se ha cortado. El área de corte debe estar del lado derecho de la cortadora de césped. Esto creará una distribución más uniforme de los recortes y un corte más uniforme.

Cuando corte áreas grandes, comience girando hacia la derecha, de modo que los recortes se descarguen lejos de los arbustos, bardas, caminos, etc. Después de una o dos vueltas, corte en la dirección opuesta, dando vueltas hacia la izquierda hasta que termine.

Si el césped está demasiado alto, se deberá cortar dos veces para reducir la carga y la posibilidad de un peligro de incendio por los recortes secos. Haga el primer corte relativa- mente alto; el segundo deberá ser a la altura deseada.

14

39

Image 14
Contents Operator’s Manual Manual de Operario 09.08.11 CLTable of Contents WarrantyAlways wear eye protection when operat- ing machine Safety RulesTabla DE Solución DE Problemas General OperationIV. Service Safe Handling of Gasoline III. ChildrenGeneral Service Almacenamiento Safety RulesProduct Specifications Customer ResponsibilitiesTo Remove Riding Mower from Carton Tools Required for AssemblyUnassembled Parts Unpack CartonCheck Battery HOW to SET UP Your Riding Mower Install Steering ColumnInstall Seat Slide steering shaft protective foam cover over shaftCheck Deck Levelness ChecklistCheck Tire Pressure Check for Proper Positon of Mower Drive BeltCortadora DE Césped Retiro DE LA Cortadora DE Servicio Y AjustesOperation Instalación DE LA Cortadora DE CéspedKnow Your Riding Mower To SET Parking Brake HOW to USE Your Riding MowerTo Adjust Mower Cutting Height StoppingTo Stop Mower Blade Using the Reverse Operation SystemTo Operate Mower Reverse Operation System ROSTo Start Engine MantenimientoBefore Starting the Engine Left hand side of mower should be used for trimming Mowing TipsRecoil Starting System Sismtema DE Arranque ManualBefore Each USE MaintenanceGeneral Recommendations Tires Riding MowerBrake Operation Axle and SpindlesEngine AIR Filter Clean AIR ScreenCleaning MufflerOperación Service and AdjustmentsTo Install Mower Riding MowerMower Drive Belt Installation To Level Mower HousingSIDE-TO-SIDE Adjustment To Replace Mower Blade Drive BeltTo Adjust Steering Wheel Alignment Cómo Configurar SU Cortadora DE CéspedTo Adjust Brake To Start Engine with a Weak Battery Replacing BatteryInterlocks and Relays Partes no EnsambladasEngine To Replace FuseEspecificaciones DEL Producto BatteryReglas DE Seguridad Storage MowerReglas DE Seguridad Troubleshooting ChartProblem Cause Correction III. NiñosOperación General II. Operación EN PendientesOnly Ride UP and Down HILL, not Across Hill Degrees MAX Tabla DE ContenidoGarantía
Related manuals
Manual 20 pages 13.36 Kb Manual 40 pages 39.3 Kb

WE261 specifications

The Weed Eater WE261 is a robust and versatile string trimmer designed to tackle a variety of lawn care tasks with ease and efficiency. Aimed at both homeowners and landscaping professionals, the WE261 is built to handle the challenges of overgrown lawns and garden beds, providing powerful performance and reliability.

One of the standout features of the WE261 is its 26cc 2-cycle engine, which delivers ample power while maintaining a lightweight profile. This engine ensures that users can navigate through dense vegetation and thick weeds without compromising performance. The 2-cycle technology allows for efficient fuel usage, providing users with longer run times between refuels.

The WE261 is equipped with a dual line bump head, which automatically releases more line as needed. This feature enhances productivity by allowing the user to focus on trimming rather than manually adjusting the string. The .095-inch line diameter provides a thick cutting path, making it effective against stubborn weeds and tall grass.

Another significant characteristic of the WE261 is its ergonomic design. The trimmer features a padded hand grip and an adjustable handle, allowing users to customize their grip for maximum comfort and control. This is especially beneficial during extended use, as it minimizes fatigue and enhances maneuverability.

The trimmer also incorporates an easy-start technology, which simplifies the starting process. Users can enjoy quick and hassle-free starts with minimal effort required. This feature is particularly useful for those who may not have extensive experience with starting gas-powered equipment.

Durability is a key consideration in the design of the WE261. Constructed with high-quality materials, this weed eater is built to withstand the rigors of regular use. The robust build ensures that it can handle various outdoor conditions, making it a reliable option for any lawn care enthusiast.

In summary, the Weed Eater WE261 presents a combination of power, efficiency, and user-friendly features. With its strong 26cc engine, automatic dual line bump head, ergonomic design, and easy-start technology, it stands out as an exceptional choice for anyone looking to maintain a well-groomed lawn. Whether dealing with overgrown areas or simply keeping the yard tidy, the WE261 is up to the task, delivering performance that users can trust.