Woods Equipment TCH4500 manual Shorten Driveline

Page 26

SHORTEN DRIVELINE

NOTE: On some smaller tractors the driveline may need to be shortened to allow connection to the PTO shaft. The pictures shown in these instructions are to be used as an example and do not show the chipper.

1.Attach equipment to the tractor 3-point hitch.

2.Raise and lower the equipment to determine the minimum distance between the tractor PTO shaft and the gearbox input shaft.

3.Leave the equipment in the minimum position.

4.Separate the driveline into two halves and connect them to the tractor PTO and equipment gearbox.

5.Place the two halves parallel to one another to determine how much the driveline must be shortened. See Figure 22.

Figure 22. Drive Halves Placed Parallel

6.Measure from the end of the upper shield to the base of the bell on the lower shield (A). Add 1- 9/16" to dimension (A). See Figure 23.

A

1-9/16"

DP3a

Figure 23. Determine Shield Length

7.Cut the shield to the overall dimension. See Figure 24.

Figure 24. Cut Shield

8.Place the cutoff portion of the shield against the end of the shaft and use it as a guide. Mark and cut the shaft. See Figure 25.

Figure 25. Cut Shaft to Length

9.Repeat step 8 for other half of drive.

10.File and clean cut ends of both the drive halves.

26 Assembly

MAN0458 (9/23/2005)

 

 

Image 26
Contents Operators Introduction To the DealerTable of Contents LEA EL InstructivoSpecifications General InformationTraining SafetySafety Rules PreparationMaintenance TransportationStorage Safety Safety & Instructional DecalsShield Missing Safety Be Careful Chipper PRE-OPERATION OperationOperation Attaching Chipper to TractorStopping the Chipper Tractor StabilityStarting the Chipper Clearing Plugged DiskStoring Chipper CleaningOperating Technique After Each UsePRE-OPERATION Check List Owners ResponsibilityService and Maintenance Schedule ServiceService LubricationInstall Disk Lock Chipper BladesBlade Removal & Cutting Edge Reversal Blade InstallationBlade Servicing Blade InspectionDrive Belt Drive Belt AdjustmentBlade Clearance Front Drive BeltFront Belt Installation Rear Drive BeltTroubleshooting TroubleshootingTroubleshooting Install 3-POINT Hitch Pins AssemblyAssembly Instructions Install Chipper HopperHinge Latch Installed Install SMV Sign Install Discharge Tube OptionalShorten Driveline PRE-DELIVERY Check List Dealer Check ListsDealer Check Lists Delivery Check ListTCH4500 Base Assembly PartsTCH4500 Base Assembly Parts List PartsChipper Upper Assembly TCH4500 Chipper Upper Assembly Parts List TCH4500 Chipper Hopper Assembly TCH4500 Chipper Hopper Assembly Parts List TCH4500 Discharge Tube KIT OptionalTCH4500 & 5000 Chipper Driveline Assembly Appendix Bolt Torque ChartSAE Series Torque Chart Metric SeriesBolt Size Chart AbbreviationsWarranty Woods Equipment Company