Woods Equipment TCH4500 manual Dealer Check Lists, PRE-DELIVERY Check List, Delivery Check List

Page 27

DEALER CHECK LISTS

PRE-DELIVERY CHECK LIST

(DEALER’S RESPONSIBILITY)

Inspect chipper thoroughly after assembly to make sure it is set up properly before delivering it to the customer. The following check list is a reminder of points to inspect. Check off each item as it is found satisfactory, corrections are made, or services are performed.

___

Check all bolts to be sure they are properly

 

torqued.

___

Check that all cotter pins are properly installed

 

and secured.

___

Check that PTO shaft is properly installed.

___

Check and grease all lubrication points as identi-

 

fied in Service, Lubrication, page 16.

___

Check that blades have been properly installed

 

with correct clearance.

DELIVERY CHECK LIST

(DEALER’S RESPONSIBILITY)

___ Show customer how to make adjustments. Describe the options available for this chipper and explain their purpose.

___ Explain importance of lubrication to customer and point out lubrication points on cutter.

___ Point out all guards and shielding. Explain their importance and the safety hazards that exist when not kept in place and in good condition.

___ For mounted units, add wheel weights, ballast in front tires, and/or front tractor weight to enhance front end stability. A minimum 20% of tractor and equipment gross weight must be on front tractor wheels. When adding weight to attain 20% of tractor and equipment weight on front tractor wheels, you must not exceed the ROPS weight certification. Weigh the tractor and equipment. Do not estimate!

___ Present Operator's Manual and request that cus- tomer and all operators read it before operating equipment. Point out the manual safety rules, explain their meanings and emphasize the increased safety hazards that exist when safety rules are not followed.

___ Explain to customer that when equipment is transported on a road or highway, safety devices should be used to give adequate warning to oper- ators of other vehicles.

™

MAN0458 (9/23/2005)

Dealer Check Lists 27

 

 

Image 27
Contents Operators To the Dealer IntroductionLEA EL Instructivo Table of ContentsGeneral Information SpecificationsPreparation SafetySafety Rules TrainingTransportation MaintenanceStorage Safety & Instructional Decals SafetyShield Missing Safety Be Careful Attaching Chipper to Tractor OperationOperation Chipper PRE-OPERATIONClearing Plugged Disk Tractor StabilityStarting the Chipper Stopping the ChipperAfter Each Use CleaningOperating Technique Storing ChipperOwners Responsibility PRE-OPERATION Check ListLubrication ServiceService Service and Maintenance ScheduleChipper Blades Install Disk LockBlade Inspection Blade InstallationBlade Servicing Blade Removal & Cutting Edge ReversalFront Drive Belt Drive Belt AdjustmentBlade Clearance Drive BeltRear Drive Belt Front Belt InstallationTroubleshooting TroubleshootingTroubleshooting Install Chipper Hopper AssemblyAssembly Instructions Install 3-POINT Hitch PinsHinge Latch Installed Install Discharge Tube Optional Install SMV SignShorten Driveline Delivery Check List Dealer Check ListsDealer Check Lists PRE-DELIVERY Check ListParts TCH4500 Base AssemblyParts TCH4500 Base Assembly Parts ListChipper Upper Assembly TCH4500 Chipper Upper Assembly Parts List TCH4500 Chipper Hopper Assembly TCH4500 Discharge Tube KIT Optional TCH4500 Chipper Hopper Assembly Parts ListTCH4500 & 5000 Chipper Driveline Assembly Metric Series Bolt Torque ChartSAE Series Torque Chart AppendixAbbreviations Bolt Size ChartWarranty Woods Equipment Company