TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
Engine or rotor stalls or stops | Obstructed discharge | Use branch or similar object to clear |
|
| discharge. |
| Plugged rotor | Clear rotor. Feed material more |
|
| evenly. |
| Feeding material too large into chipper | Reduce size of material being fed into |
|
| chipper. |
|
|
|
Hard to feed chipper, requires | Dull chipper blades | Reverse or sharpen blades. |
excessive power to chip |
|
|
| Obstructed discharge | Use branch or similar object to clear |
|
| discharge. |
| Improper blade clearance | Adjust clearance between chipper |
|
| block and chipper blades. |
|
|
|
Chipper requires excessive power or | Obstructed discharge | Use branch or similar object to clear |
stalls |
| discharge. |
| Plugged rotor | Clear rotor. Feed material more |
|
| evenly. |
| Wet or green material will not | Alternately feed dry material. |
| discharge |
|
|
|
|
Engine stalls or belt squeals when | Engine clutch too fast | Lower the engagement handle more |
engaging clutch |
| slowly |
| Plugged rotor | Clear rotor. Feed material more |
|
| evenly. |
| Belt tension too loose | Replace belt or spring. |
|
|
|
Material from chipper wraps around | Stringy, green material bypasses | Rotate branch of material when |
rotor shaft | chipper blades | feeding to cut completely. |
| Dull chipper blades | Reverse or sharpen blades. |
| Improper blade clearance | Adjust clearance between chipper |
|
| block and chipper blades. |
|
|
|
Excessive vibration while running. | Drive system vibration | Check drive belts and pulleys for badly |
|
| worn areas. Check for dull blade. |
| Rotor out of balance | Inspect rotor for broken or missing |
|
| blades; replace if needed. Check rotor |
|
| to see if it wobbles. Check to see if |
|
| rotor is assembled correctly. |
| Chipper blade to chipper block | Set chipper blade/block clearance to |
| clearance is incorrect | recommended distance (1/16" to 1/8"). |
|
|
|
MAN0458 (9/23/2005) | Troubleshooting 21 |
|
|