American Dryer Corp Phase 7.2.2 user manual Programming Flowcharts, Start/Enter Stop/Clear

B. PROGRAMMING FLOWCHARTS

The following section of this manual explains the programming of the preprogrammed cycles and Program Locations (system parameters) through the use of flowcharts. A flowchart is a diagram of the programming process.

Four (4) different symbols will be used in the flowcharts:

display symbol

Ready

key symbol

START/ENTER STOP/CLEAR

Each display symbol will represent a readout on the Phase 7 non-coin microprocessor controller (computer) light emitting diode (L.E.D.) display, and each key symbol will represent a key that is pressed. For example:

1.If the flowchart shows the symbol L.E.D. display will read the same.

2.If the flowchart shows the symbol

Ready , the Phase 7 non-coin microprocessor controller (computer)

, press that specific key on the keyboard (touch pad) label.

3.This symbol represents “STOP/CLEAR”.

4.This symbol represents “START/ENTER”.

a.The flowchart arrows (i.e., ) represents the program path.

b.On the sides of the flowcharts are explanations of the flowchart procedure, and in some cases, the programming limits.

Listed below is an index of the flowcharts on the following pages.

		Flowchart Titles
		Page
Entering and Exiting Program Mode		......................................................................................................... 26
System Parameters (Program):
0	LANGUAGES	29
1	SYSTEM PARAMETERS	30
2	“A-F” CYCLES	59
3	“0-40” CYCLES	59
4	DEFAULT SETTINGS	72

25