SECTION VI
PROGRAMMING INSTRUCTIONS
A. INTRODUCTION TO PROGRAMMING
The various program selections are stored in the Phase 7
0.Language (ENGLISH, FRANCAIS, ESPANOL, ITALIANO, and DEUTSCH).
1.System Parameters (Dryer Setup, Display Setup, Cool Down Setup, and Wrinkle Guard Setup).
2.Preprogrammed Cycles (Keys
This feature allows the operator to have the six (6) most commonly used cycle selections awaiting the push of a single keyboard (touch pad) entry, to start the dryer.
3.Preprogrammed Cycles
This feature allows the operator to have an additional 
key.
4.Default Settings (returns ALL programmable parameters to factory default settings).
Both the preprogrammed cycles and the system parameters (programs) have been preprogrammed by the factory with the parameters shown in Section VII of this manual. The various program selections for the preprogrammed cycles and system parameters are outlined in Section III of this manual.
ALL program changes for the preprogrammed cycles and system parameters (programs) are done through the keyboard (touch pad) selection keys on the front of the control panel.
ENTERING THE PROGRAMMING MODE:
First, make sure that no cycle is in progress and that the light emitting diode (L.E.D.) display reads “READY”, and then press the “STOP/CLEAR” 
key and the “UP ARROW” 
key at the same time. This will put the Phase 7
EXITING THE PROGRAMMING MODE:
The “STOP/CLEAR” 
key will return you to the previous menu level. Continue to press the “STOP/CLEAR” 
key until the Phase 7
23
