76
SECTION VIII

PHASE 7 NON-COIN MICROPROCESSOR CONTROLLER

(COMPUTER) PROGRAMMING LIMITS

A. PREPROGRAMMED CYCLES

1. Automatic Drying Cycle (Patent No. 4,827,627)
a. Drying Temperature from 160° F to 200° F (71° C to 93° C) in one-degree increments for a radial dryer,
and 100° F to 160° F (38° C to 71° C) in one-degree increments for an axial dryer.
b. Cycle Adjustment V alue from 0-99, in increments of one (1).
c. Cool Down Time from 0 to 99 minutes, in 1 minute increments.
d. Cool Down Temperature from 70° F to 100° F (21° C to 38° C), in one-degree increments.
2. Timed (Manual) Drying Cycle
a. Drying Temperature from 100° F to 200° F (38° C to 93° C) in one-degree increments for a radial dryer,
and 100° F to 160° F (38° C to 71° C) in one-degree increments for an axial dryer.
b. Drying Time from 0 to 99 minutes, in 1 minute increments.
c. Cool Down Time from 0 to 99 minutes in 1 minute increments for preprogrammed cycle.
d. Cool Down Temperature from 70° F to 100° F (21° C to 38° C), in one-degree increments.
e. Reversing Models
1) Automatic Drying Cycle (Patent No. 4,827,627) Spin Time and Dwell (Stop) Time are not
programmable. (Refer to Fixed Parameters on next page).
2) Manual Timed Cycle
a) Spin Time (“SPIN TIME”) from 30-seconds to 120-seconds, in 1-second increments.
b) Dwell (Stop) Time (“ST O P TIME”) from 5-seconds to 10-seconds, in 1-second increments.