American Dryer Corp Phase 7.2.2 user manual Light Emitting Diode L.E.D. DOT Matrix Display

E. LIGHT EMITTING DIODE (L.E.D.) DOT MATRIX DISPLAY

The L.E.D. display informs the user of cycle status, program verification, and displays important diagnostic and fault information. A complete listing of the various display messages and their meanings is shown in Section V of this manual.

CYCLE IN PROGRESS DISPLAY STATUS

During the Drying Cycle, the display will indicate the type of cycle in progress by presenting either one (1) of the following:

1.“AUTO DRYING CYCLE” – Manually Loaded Auto Cycle.

2.“AUTO DRYING CYCLE #” – The “#” is replaced with “A-F” or “0-40”.

3.“MANUAL DRYING CYCLE” – Manually Loaded Manual Cycle.

4.“MANUAL DRYING CYCLE #” – The “#” is replaced with “A-F” or “0-40”.

F.CYCLE IN PROGRESS TEMPERATURE DISPLAY

While the dryer cycle is in progress, the temperature in the basket (tumbler) can be displayed by pressing and holding the “UP ARROW” key. The temperature will be displayed in either Fahrenheit (°F) or Celsius (°C), depending on which temperature system has been set in the “DRYER SETUP”.

G. TEMPERATURE CONVERSION STATUS

Temperature related programs are programmable to be operated in either Fahrenheit (°F) or Celsius (°C). The temperature selection is made in “SYSTEM TEMP”. The programs affected are as follows:

1.Temperature Display Mode

2.Drying Temperatures

3.Cool Down Temperatures

IMPORTANT: When changing the temperature conversion status from Fahrenheit to Celsius, or vice versa, ALL of the Temperature Selections and Cool Down Temperatures will be changed accordingly. The Phase 7 non-coin microprocessor controller (computer) automatically calculates and converts the temperatures in these programs to the previously set value. For example, if the preprogrammed Cycle “A” drying temperature was set for 160° F, when converting from °F to °C, the Phase 7 non-coin microprocessor controller (computer) will change to 71° C (+/- 1° Celsius).

9