CLEANING
After Each Use
●Remove large debris such as clumps of dirt, grass, crop residue, etc. from machine.
●Inspect machine and replace worn or damaged parts.
●Replace any safety decals that are missing or not readable.
Periodically or Before Extended Storage
●Clean large debris such as clumps of dirt, grass, crop residue, etc. from machine.
●Remove the remainder using a
1.Be careful when spraying near scratched or torn safety decals or near edges of decals as water spray can peel decal off surface.
2.Be careful when spraying near chipped or scratched paint as water spray can lift paint.
3.If a pressure washer is used, follow the advice of the pressure washer manufacturer.
●Inspect machine and replace worn or damaged parts.
●Sand down scratches and the edges of areas of missing paint and coat with Woods spray paint of matching color (purchase from your Woods dealer).
●Replace any safety decals that are missing or not readable (supplied free by your Woods dealer). See Safety Decals section for location drawing.
RETURNING TO OPERATION
When you have completed service and maintenance functions, read and comply with these safety mes- sages before returning unit to operation.
Be sure either the discharge chute, mulching end cap, or complete vacuum attachment is installed and in good condition. Replace if dam- aged.
Make sure the driveline
Make sure shields and guards are properly installed and in good condition. Replace if damaged.
Make sure all safety decals are installed. Replace if damaged. (See Safety Decals section for location.)
CAUTION
Tighten all bolts, nuts, and screws to torque chart specifications. Check that all cotter pins are installed securely to ensure equipment is in a safe condition before putting unit into service.
MAN0253 (Rev. 3/10/2007) | Service 21 |
|
|