Woods Equipment MX54T, MX61T manual Install Discharge Chute Figure, Preparation All Models

Page 23

Install Discharge Chute (Figure 19)

Be sure either the discharge chute, mulching end cap, or complete vacuum attachment is installed and in good condition. Replace if dam- aged.

Figure 19. Discharge Chute Installation

NOTE: The pre-assembled discharge shield, which includes hinge and hardware, must be installed on mower deck.

1.Remove one safety pin and hinge pin to free dis- charge chute from the shipping position, (Diagram A).

2.Place the discharge chute in the operating position. Install hinge pin through spring and hinge bracket.

NOTE: Make sure spring is installed on top of dis- charge chute hinge bracket as shown in Diagram B.

3.Reinstall safety pin to secure discharge chute.

ATTACHING MOWER TO POWER UNIT

Preparation - All Models

NOTICE

■The power unit must comply with counterweight requirements before attaching to power unit.

1.Place power unit and mower on a level surface.

2.Rotate parking stand to the down position so deck is resting on the parking stand wheel.

3.Center the power unit behind mower as close as possible. Shut off engine.

NOTE: For MX54/MX61 Manual Height Adjustment Models, skip to Deck Attachment, page 26.

(Rev. 12/22/2007) MAN0253 (Rev. 3/10/2007)

Assembly 23

Image 23

Contents MAN0253 To the Dealer IntroductionLEA EL Instructivo Table of ContentsGeneral Information SpecificationsPreparation SafetySafety Rules TrainingStorage MaintenanceMX54 & MX61 Safety & Instructional DecalsBe Careful Operation Attaching Mower to Power UnitOperation PowerTilt Operation & Figure Cutting Height AdjustmentTo tilt deck up Mower SIDE-TO-SIDE AdjustmentStorage Position Mowing TipsMowing Conditions TroubleshootingBelt Conditions Mowing ConditionsOwners Responsibility PRE-OPERATION Check ListLubrication ServiceService Blade Sharpening Blade ServiceBlade Installation Blade RemovalBelt Replacement Belt ServiceBelt Adjustment Figure Spindle Repair Figure Spindle Removal Spindle DisassemblySpindle Assembly Rear Pivot Lift ARM ServiceLift Linkage Bushing Replacement Caster Wheel MaintenanceReturning to Operation CleaningAfter Each Use Periodically or Before Extended StorageDealer SET-UP Instructions AssemblyAssembly Instructions Mower Assembly FigurePreparation All Models Install Discharge Chute FigureWiring Connection MXT Deck SN 1100886 & above Wiring Connections MXT Deck SN 1100886 and aboveFZ Series Power Units without timer delay Figure Deck Attachment All Models Adjust Mower Deck & FigureAdjust Mower SIDE-TO-SIDE Adjust Cutting HeightApply Deck Height Decal PowerTilt Units Anti-Scalp Height Adjustment Linkage PowerTilt Models Delivery Check List Dealer Check ListsDealer Check Lists PRE-DELIVERY Check ListParts MOW’N Machine Mower DeckMX54 & MX61 Deck Assembly Part QTY Description MX54 & MX61 Deck Assembly Parts ListMX54T & MX61T Deck Assembly with Powertilt Parts Deck Drive System Deck Drive System Parts List Right Angle Gearbox Assembly Floating Deck Lift ARM Powertilt Assembly For MX54/MX61 Manually Controlled Cutting Height Height Adjustment Handle AssemblyWheel Lift Assembly Blade Spindle Assembly Mulch KIT Parts Powertilt with Timer Delay FZ Series Metric Series Bolt Torque ChartSAE Series Torque Chart AppendixAbbreviations Bolt Size ChartIndex IndexLimited Warranty Warranty Woods Equipment Company