SERVICE
The information in this section is written for operators who possess basic mechanical skills. If you need help, your dealer has trained service technicians available. For your protection, read and follow the safety informa- tion in this manual.
Before performing any service or maintenance, lower attachment to ground, turn off power unit engine, remove key, and disconnect battery ground cable (negative
Do not drive or operate mower in optional
Keep hands, feet, hair, and clothing away from equipment while engine is running. Stay clear of all moving parts.
Keep all persons away from operator control area while performing adjustments, service, or maintenance.
CAUTION
Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy,
LUBRICATION
1.Do not let excess grease collect on or around parts, particularly when operating in sandy areas.
2.See Figure 7 for lubrication points and frequency of lubrication based on normal operating conditions. Severe or unusual conditions may require more frequent lubrication.
3.Use a lithium grease of #2 consistency with a MOLY (molybdenum disulfide) additive for all loca- tions unless otherwise noted. Be sure to clean fit- tings thoroughly before attaching grease gun. One good pump of most guns is sufficient when the lubrication schedule is followed.
4.Gearbox requires a minimum of 3 fl. oz. of 90W gear oil. Do not use more than 6 fl. oz.
DESCRIPTIONFREQUENCY
1. | Mower Blade Spindles | 40 | Hours |
2. | Front Gauge Wheel | 8 | Hours |
3. | Drive Shaft | 8 | Hours |
4. | Caster Pivot | 40 | Hours |
5. | Front Lift Linkage | 40 | Hours |
6. | Deck Pivot | 8 | Hours |
7. | Gearbox | 500 hours | |
Figure 7. Lubrication Points
16 Service | MAN0253 (Rev. 3/10/2007) |
|
|