Yazoo/Kees ZCBI48181 manual To Sharpen Blade See Fig, Battery

Page 24

CUSTOMER RESPONSIBILITIES

IMPORTANT:TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON CUTTER HOUSING.

•Install and tighten blade bolt securely (45-55 ft./lbs. torque).

IMPORTANT: SPECIAL BLADE BOLT IS HEAT TREATED.

CUTTER

HOUSING

BLADE

CENTER HOLE

STAR

BLADE BOLT (SPECIAL)

FIGURE 8

TO SHARPEN BLADE (See Fig. 9)

WARNING

When it is necessary to raise the mower for any repair or service, use jackstands to provide adequate sup- port. DO NOT rely on hydraulic or me- chanical jacks

Care should be taken to keep the blade bal- anced. An unbalanced blade will cause exces- sive vibration and eventual damage to mower and engine.

•The blade can be sharpened with a file or on a grinding wheel. Do not attempt to sharpen while on the mower.

•To check blade balance, you will need a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone balancer, follow the instructions supplied with balancer.)

NOTE: Do not use a nail for balancing the blade. The lobes of the center hole may appear to be centered, but are not.

•Slide blade on to an un-threaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If the blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced.

CENTER HOLE

5/8" BOLT

BLADE

OR PIN

 

FIGURE 9

BATTERY

Your mower is equipped with a maintenance free battery and does not need servicing. However, periodic charging of the battery with an automotive type battery charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Recharge at 6-10 amperes for 1 hour

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Operators Manual Models ZCBI48181Good Service Contents Symbols and Decals Safety Instructions Safety InstructionsGeneral Use Personal protective equipment Driving on Slopes Do as followsChildren 8011-563 Transport Important InformationSpecifications Customer ResponsibilitiesAssembly Tools Required For AssemblyTo Remove the Mower from Crate Before Removing Mower from the SkidOn position Checklist Check the Tire PressureOperation ControlsIZT Integraded Zeroturn TransaxleBYPASS Linkages HOW to USE Your Mower Deck BladesEngine To Adjust the Deck Cutting Height See Fig To Adjust ANTI-SCALP Rollers See FigureTo Operate Mower To Operate on HillsTo Transport See Fig Before Starting the Engine To Start Engine See FigCheck Engine OIL Level ADD GasolineMowing Tips Maintenance Schedule General RecommendationsBefore Each USE Lubrication Chart Operator Presence SystemBlade Care TiresBattery To Sharpen Blade See FigClean AIR Screen Clean AIR INTAKE/COOLING AreasBelts EngineCleaning AIR FilterEngine OIL Filter Spark PlugsService and Adjustment Before Performing ANY Service or AdjustmentsMower To Level DeckFRONT-TO-BACKADJUSTMENTSee Fig To Replace Deck BeltTo Replace IZT Integraded Zeroturn Transaxle Belt See Fig To Adjust the Seat See Fig To Adjust Control Levers See FigTo Start AN Engine with a Weak Battery To Remove Wheels for RepairReplacing Battery See Fig To Attach Jumper CablesTo Adjust Park Brake Tracking AdjustmentBattery StorageFuel System Engine OILOther CylindersTroubleshooting Points Problem Cause CorrectionProblemcausecorrection Attachment Poor cut unevenWiring Schematic Page
Top Page Image Contents