Yazoo/Kees ZCBI48181 manual Replacing Battery See Fig, To Attach Jumper Cables

Page 31

SERVICE AND ADJUSTMENT

TO ATTACH JUMPER CABLES

Connect each end of the RED cable to the POSITIVE (+) terminal on each battery, taking care not to short against chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully charged battery.

Connect the other end of the BLACK cable to a good CHASSIS GROUND, away from the fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER

BLACK cable first from chassis and then from the fully charged battery.

RED cable last from both batteries.

REPLACING BATTERY (See Fig. 18)

WARNING

Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal brace- lets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

Lift Seat and rotate forward.

Open terminal access doors.

Using two 1/2" wrenches disconnect BLACK battery cable then RED battery cable.

Using 7/16" wrench, remove terminal guard.

Carefully remove the battery from the mower.

Install new battery with terminals in the same position as the old battery.

Reinstall terminal guard

First connect RED battery cable to positive (+) battery terminal with hex bolt and hex nut.

Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and hex nut.

Tighten securely.

Close terminal access doors.

Lower seat.

TERMINAL

 

GUARD

 

 

TERMINAL

 

ACCESS

 

DOORS

FIGURE 18

CZ-22

 

31

Image 31
Contents ZCBI48181 Operators Manual ModelsGood Service Contents Symbols and Decals Safety Instructions Safety InstructionsGeneral Use Personal protective equipment Do as follows Driving on SlopesChildren 8011-563 Important Information TransportCustomer Responsibilities SpecificationsBefore Removing Mower from the Skid AssemblyTools Required For Assembly To Remove the Mower from CrateOn position Check the Tire Pressure ChecklistControls OperationIZT Integraded Zeroturn TransaxleBYPASS Linkages Deck Blades HOW to USE Your MowerEngine To Adjust the Deck Cutting Height See Fig To Operate on Hills To Adjust ANTI-SCALPRollers See Figure To Operate MowerTo Transport See Fig ADD Gasoline Before Starting the EngineTo Start Engine See Fig Check Engine OIL LevelMowing Tips General Recommendations Maintenance ScheduleBefore Each USE Tires Lubrication ChartOperator Presence System Blade CareTo Sharpen Blade See Fig BatteryEngine Clean AIR ScreenClean AIR INTAKE/COOLING Areas BeltsSpark Plugs CleaningAIR Filter Engine OIL FilterTo Level Deck Service and AdjustmentBefore Performing ANY Service or Adjustments MowerTo Replace Deck Belt FRONT-TO-BACKADJUSTMENTSee FigTo Replace IZT Integraded Zeroturn Transaxle Belt See Fig To Remove Wheels for Repair To Adjust the Seat See FigTo Adjust Control Levers See Fig To Start AN Engine with a Weak BatteryTo Attach Jumper Cables Replacing Battery See FigTracking Adjustment To Adjust Park BrakeEngine OIL BatteryStorage Fuel SystemCylinders OtherProblem Cause Correction Troubleshooting PointsAttachment Poor cut uneven ProblemcausecorrectionWiring Schematic Page