Shindaiwa C2510, 89303 manual Mixing fuel, Filling the fuel tank, Examples of 501 mixing quantities

Page 10

Mixing fuel

CAUTION!

Never use any type of gasoline con- taining more than 10% alcohol by vol- ume! Some types of gasoline contain alcohol as an oxygenate. Oxygenated gasoline may cause increased operat- ing temperatures. Under certain con- ditions, alcohol-based gasoline may also reduce the lubricating qualities of some 2-cycle mixing oils.

Generic oils and some outboard oils should never be used in your Shindaiwa engine.

CAUTION!

This engine is designed to operate on a 50:1 mixture consisting of unleaded gasoline and ISO-L-EGD or JASO FD class 2-cycle mixing oil only. Use of non-approved mixing oils can lead to excessive carbon deposits.

ŶUse only fresh, clean unleaded gasoline with a pump octane of 87 or higher.

ŶMix all fuel with a 2-cycle air-cooled mixing oil that meets or exceeds ISO-L- EGD and/or JASO FD classified oils at 50:1 gasoline/oil ratio.

CAUTION!

Mix and pour fuel outdoors where WKHUHDUHQRVSDUNVDQGÀDPHV

Examples of 50:1 mixing quantities

U.S.

METRIC

Gasoline

2-cycle

Gasoline

2-cycle

mixing oil

mixing oil

US Gallons

Fl.oz.

Liter

cc.

1

2.6

4

80

2

5.2

8

160

5

13

20

400

10

25.6

30

600

20

51.2

50

1000

50

128

100

2000

IMPORTANT!

Mix only enough fuel for your immediate needs! If fuel must be stored longer than 30

days and oil with fuel stabilizer is not used, it should first be treated with a fuel stabilizer such as STA-BIL™.

Oil is a registered JASO FD classi- fied oil and also meets or exceeds ISO-L-EGD performance requirements. Shindaiwa One is recommended for use in all Shindaiwa low emis- sions engines. Shindaiwa One also includes a fuel stabilizer.

Filling the fuel tank

WARNING!

Minimize the Risk of Fire

ŶNEVERVPRNHRUOLJKW¿UHVQHDUWKH engine.

ŶALWAYS stop the engine and allow it to cool before refueling.

ŶALWAYS Wipe all spilled fuel and move at least 3 meters (10 feet) from the fueling point and source before starting.

ŶNEVERSODFHÀDPPDEOHPDWHULDO FORVHWRWKHHQJLQHPXIÀHU

ŶNEVER operate the engine without the

PXIÀHUDQGVSDUNDUUHVWHUVFUHHQLQ place and in good working condition.

ŶFUEL IS HIGHLY FLAMMABLE.

ŶALWAYS store gasoline in a con-

WDLQHUDSSURYHGIRUÀDPPDEOHOLTXLGV

ŶALWAYS inspect the unit for fuel leaks before each use. During each

UH¿OOFKHFNWKDWQRIXHOOHDNVIURP around the fuel cap and/or fuel tank. If fuel leaks are evident, stop using the unit immediately. Fuel leaks must be repaired before using the unit.

ŶALWAYS move the unit at least 3 meters (10 feet) away from a fuel

VWRUDJHDUHDRURWKHUUHDGLO\ÀDP- mable materials before starting the engine.

1.Place the unit on a flat, level surface.

2.Clear any dirt or other debris from around the fuel filler cap.

CAUTION!

Slowly remove the fuel cap only after stopping the engine

3.Remove the fuel cap, and fill the tank with clean, fresh fuel.

4.Reinstall the fuel filler cap and tighten firmly.

5.Wipe away any spilled fuel before start- ing engine.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Brushcutter Contents IntroductionWork Safely SafetySafety Labels Stay AlertProperly Equipped Operator Be Aware of the Working EnvironmentProduct Description 6SHFLÀFDWLRQVInstall the handlebar AssemblyPrior to Assembly Handlebar C unitSub-Shield When trimmer head is in use Cutting Attachment Shield C unitRemove the hex wrench from the gearcase and holders Adjust throttle lever free playInstall trimmer head Throttle Lever Free PlayInstall blade holder B on the output shaft Installing Brushcutter BladeInstall blade holder B on the output shaft Remove the hex wrenchExamples of 501 mixing quantities Mixing fuelFilling the fuel tank Minimize the Risk of FireDepress and hold the throttle lock button When the Engine StartsStarting the Engine Press primer BulbStopping the Engine Adjusting Engine IdleIdle Speed Adjustment Checking Unit ConditionOperation Blade Thrust Using a bladeBrushcutter Shoulder Strap Brushcutter HandlebarMaintenance Remove and clean or replace the spark plug Hour maintenance10/15-Hour maintenance Gearcase lubricationMaintenance after first 139-hours 139/150-Hour MaintenanceValve Adjustment Remove and replace the fuel filter ElementLong Term Storage 0XIÁHUDQGVSDUNDUUHVWHU DlqwhqdqfhShindaiwa Tornado Blade Blade SharpeningMultiple-tooth Circular Blade What To Check Troubleshooting GuideEngine does not Start RemedyIs the engine overheating? LOW PowerPossible Cause Engine is knockingAdditional Problems What To Check Possible Cause RemedyEmission System Warranty Statement NOTAs RemarquesDesmalezadora C2510 Declaraciones De Seguridad IntroducciónContenido Etiquetas de seguridadMantengase Alerta SeguridadTrabaje con cuidado Etiquetas de seguridadEsté alerta del area de trabajo Seguridad continuaciónEl operario debidamente equipado Máquina descalzoDescripción del Producto VshflàfdflrqhvMango tipo bicicleta EnsamblajeAntes de Ensamblar SP6SP7 Protector Secundario cuando elProtector del accesorio de corte Unidad TXInstalación del cabezal de corte Ensamblaje continuacionAjuste la holgura del acelerador Retire la llave hexagonalInstalación de la cuchilla desmalezadora Ejemplos de cantidades de mezcla a proporción de Mezcla de CombustibleLlenando el Tanque de Combustible Disminuya el riesgo de incendiosArranque del motor Al arrancar el motorApgado del motor ApagadoCorte de Césped Máquinas Equipadas con Cabezal de Corte OperaciónCorrea de Hombro BordesOperación continuación Mantenimiento Mantenimiento cada 50 horas Mantenimiento continuaciónMantenimiento cada 10 horas Más frecuentemente en condiciones rigurosasRetire y reemplace el elemento del filtro Mantenimiento Cada 139/150 HorasAjuste de válvulas Un ajuste incorrecto de las válvuRetire la malla y limpie con un cepillo de cerdas gruesas Mantenimiento de la silenciadorAlmacenamiento de Largo Plazo Repita los pasos 1 y 2 hasta que el motor ya no arranqueDisco Shindaiwa Tornado Discos de dientes múltiplesQué revisar Guía DiagnósticoEL Motor no Arranca Posible causaLimpiar, reparar o sustituir en caso necesario Baja Potencia¿Se sobrecalienta el motor? El motor golpeaGuía Diagnóstico continuación Cobertura de la Garantía del Fabricante Esta garantía es administrada porSus Derechos y Obligaciones de Garantía Que Está Cubierto Por Esta GarantíaTualatin, Oregon 97062 USA 11, Ozuka-Nishi Débroussailleuse Numéro de référence 89303 Rév /2009Table des matières Mises en gardeDemeurer alerte SécuritéSécurité au travail Étiquettes de sécuritéÉquipement complet de l’utilisateur Sécurité suiteTenir compte de l’environnement de travail Nomenclature Caractéristiques techniquesAvant l’assemblage Installation du guidonAssemblage GuidonPÁHFWHXULQIpULHXUlorsque la tête Assemblage suitePÁHFWHXU FR7FR8 Installer la tête de coupeRéglage du jeu du levier d’accélération Réglage du jeu du levier d’accélérationInstallation de la lame de débroussailleuse Exemples de quantités de mélange de carburant à Mélange de carburantRemplissage du réservoir à carburant Réduire les risques d’incendieGlisser le commutateur d’allumage sur la Position Marche Démarrage du moteurLorsque le moteur démarre Placer le levier de l’starter en position « fermée »Réglage du ralenti du moteur Démarrage du moteur suiteArrêt du moteur Contrôle de l’état de l’appareilFonctionnement Harnais de débroussailleuse Fonctionnement suiteUtilisation d’une lame Rebond de lameEntretien Entretien aux 10 à 15 heures Entretien suiteEntretien aux 10 heures Entretien aux 50 heuresEntretien aux 139 heures Remplacement du filtre à carburantEntretien toutes les 50 heures suite Réglage du jeu des soupapesRemisage à long terme Entretien du silencieuxLame circulaire à plusieurs dents Affûtage de la lameLame Shindaiwa Tornado Lame Shindaiwa TornadoLE Moteur NE Démarre PAS SolutionGuide de dépannage Points à contrôlerLe moteur surchauffe-t-il ? Guide de dépannage suitePuissance Insuffisante Le moteur cognePoints à contrôler Cause probable Solution Autres ProblèmesCouverture de la garantie des fabricants La présente garantie est administrée parVos droits et obligations en vertu de la garantie Couverture de la garantie
Top Page Image Contents