DCA-70USJ — OUTPUT TERMINAL PANEL FAMILIARIZATION
120VAC GFCI Receptacles
There are two 120 VAC, 20 amp GFCI (Duplex Nema
Pressing the reset button resets the GFCI receptacle after being tripped. Pressing the Test Button (See Figure 9) in the center of the receptacle will check the GFCI function. Both receptacles should be tested at least once a month.
Figure 9. G.F.C.I. Receptacle
Twist Lock Dual Voltage 120/240 VAC Receptacles
There are three 120/240V, 50 amp auxilliary
Each auxilliary receptacle is protected by a 50 amp circuit breaker.These breakers are located directly above the GFCI receptacles. Remember the load output (current) on all three receptacles is dependent on the load requirements of the Output Terminal Lugs.
Turn the voltage regulator control knob (Figure 11) on the control panel to obtain the desired voltage.Turning the knob clockwise will increase the voltage, turning the knob counter- clockwise will decrease the voltage.
Figure 11.Voltage Regulator Control Knob
Removing the Plastic Face Plate (HardWire Hookup Panel)
The Output Terminal Lugs are protected by a plastic face plate cover (Figure 12).
After the load wires have been securely attached to the terminal lugs, reinstall the plastic face plate.