Marantz Model SC-11S1 HOW to USE and SET Features, ATT. Attenuation Subsonic Filter, Tone button

HOW TO USE AND SET FEATURES

ATT. (ATTENUATION)		SUBSONIC FILTER
	ATT. button	TONE button
		DISPLAY	ATT.
DISPLAY	ATT.
			PHONO
		TONE	MC
	PHONO
TONE	MC
			POWER ON/OFF
		PHONES	PHONES
		INPUT SELECTOROUT	PRE OUTVOLUME
POWER ON/OFF
PHONESPHONES
INPUT SELECTOROUT	PRE OUT	VOLUME

ENGLISH

ATT is a one-touch feature for reducing the volume level.When the ATT button on either the unit or remote controller is pressed, the volume level is attenuated.

1.When the ATT button on either the unit or the remote controller is pressed, “ATT” flashes on the display and the volume level is reduced.

When the ATT button is pressed again or the volume is increased/decreased using the controls, the mode is canceled and the original volume level is restored.

2.When the ATT button is pressed with the volume level at -∞(muted), the display will change as it is shown below appears for about 3 seconds, and attenuation is not applied.

7How to Set Attenuation Level

Attenuation level can only be set using the ATT button on the unit. The attenuation level can be set at –20dB, -40dB, or -∞. The factory default setting is -20dB.

1.Press and hold the ATT button on the unit for 2 seconds or longer. The attenuation level will appear on the display.

2.The attenuation level setting value changes with each press of the ATT button on the unit.

3.When the desired attenuation level setting appears on the display, leave it unchanged for 2 seconds or longer to enter the setting. Once entered, the display returns to the volume level indication.

If a warped analog record or disc recorded with super-low bass is played, the speaker diaphragm may vibrate unusually and the disc may not be played correctly.

In such cases, the subsonic filter can be set to block the super-low bass output component. Press the TONE button for 2 seconds or more to set the subsonic filter ON/OFF.

When the subsonic filter is switched from ON to OFF, the ON/ OFF condition of the subsonic filter is displayed for 3 seconds, as shown below.

After displaying the ON/OFF condition, the display returns to the volume display.

Display before pressing the TONE button

Press the TONE button for 2 seconds or longer

Display after 3 seconds have passed

Set to ON Set to OFF

21