Marantz Model SC-11S1 manual How to Trim Bass, How to Trim Treble

HOW TO USE AND SET FEATURES

7How to Trim Bass

The bass level of the left and right channels can be trimmed in 2dB steps across a –8.0 – +8.0dB range. When this unit is shipped from the factory, the bass level is set to 0 dB. To trim the bass level, active tone control by pressing the TONE button on either the unit or the remote controller.

1.Press the TRIM button once to access the LEVEL trimming mode.

2.Press the ENTER button once to access the BASS trimming mode.

3.The flashing “0” on the left indicates that trimming is activated for the left channel bass level. Press the 3 and 4 buttons to set the bass level of the left channel.

4.Press the 2 button to start the “0” on the right side flashing. When the right side “0” starts flashing, trimming is activated for the right channel bass level. Press the 3 and 4 buttons to set the bass level of the right channel.

5.To trim the bass level of the ID 2 (slave) unit, press the TRIM button again and set the bass level as in steps 2-4. After that, pressing the TRIM button again allows you to trim the bass level for the “ID 3” unit and so forth.

6.When finished with bass level trimming, press the EXIT button.

7How to Trim Treble

The treble level of the left and right channels can be trimmed in 2dB steps across a –8.0 – +8.0dB range. When this unit is shipped from the factory, the bass level is set to 0 dB. To trim the treble level, active tone control by pressing the TONE button on either the unit or the remote controller.

1.Press the TRIM button once to access the LEVEL trimming mode.

2.Press the ENTER button twice to access the TREBLE trimming mode.

3.The flashing “0” on the left indicates that trimming is activated for the left channel treble level. Press the 3 and 4 buttons to set the treble level of the left channel.

4.Press the 2 button to start the “0” on the right side flashing. When the right side “0” starts flashing, trimming is activated for the right channel treble level. Press the 3 and 4 buttons to set the treble level of the right channel.

5.To trim the treble level of the ID 2 (slave) unit, press the TRIM button again and set the treble level as in steps 2-4. After that, pressing the TRIM button again allows you to trim the treble level for the “ID 3” unit and so forth.

6.When finished with treble level trimming, press the EXIT button.

ENGLISH

23