Section 4
SCR 2K IOS
Figure 4-7 Improper Operation on a Slope
4.Fill the fuel tank with fresh, clean fuel at the end of every day of operation.
5.Check the tire pressure. Inflate tires if necessary.
4.10HOPPER, MULCH or SIDE DISCHARGE OPERATION
When mowing with the cutting deck setup for rear discharge into the hopper (Figure
4.8 PARKING THE MOWER
1.Place the speed control in the neutral position.
2.Slow the engine to idle speed.
3.Engage the parking brake.
4.Turn the ignition key to the OFF position and remove the key.
4.9 AFTER OPERATION
1.Wash the entire mower after each use. Do not use high pressure spray or direct the spray onto electrical components.
Do not wash a hot or running engine. Cold water will damage the engine. Use compressed air to clean the engine if it is hot.
2.Keep the entire mower clean to inhibit serious heat damage to the engine or hydraulic oil circuit.
3.Check the drive belts for proper alignment, correct if necessary. Remove any debris build up.
Blower Belt
Blower Belt
Release Pedal
SCR 2K BBR
Figure 4-8 Blower Belt Release
Rear Discharge
Baffle
SCR 2K RD
Side Discharge
Shutoff Baffle
Figure 4-9 Baffles for Rear Discharge
15