Section 2
5.DO NOT wear loose fitting clothing that could get tangled in moving parts. Do not operate the machine wearing shorts; always wear adequate protective clothing including long pants. Wearing safety glasses, safety shoes and a helmet is advisable and is required by some local ordinances and insurance regulations.
6.Operator hearing protection is recommended, particularly for continuous operation of the mower. Wear suitable hearing protection. Prolonged exposure to loud noise can cause hearing impairment or loss.
7.Keep the machine and attachments in good operating condition. Keep all shields and safety devices in place. If a shield, safety device or decal is defective or damaged, repair or replace it before operating the machine.
WARNING:
12.Equipment must comply with the latest requirements per ANSI J137 and/or ANSI S279 when driven on public roads.
If the mower is driven on public roads, it must comply with state and local ordinances as well as SAE J137 and/or ANSI / ASAE S279 requirements. Contact your local authorities for regulations and equipment requirements.
13.DO NOT operate without a chute deflector installed; keep the deflector in lowest possible position.
14.Check the blade mounting bolts at frequent intervals for proper tightness.
15.Make sure all hydraulic fluid connections are tight and all hydraulic hoses and lines are in good condition before starting the machine.
This machine is equipped with an interlock system intended to protect the operator and others from injury. This is accomplished by preventing the engine from starting unless the operator is seated in the seat, the deck drive is disengaged, and the speed control is placed in the neutral position with the parking brake applied. The system also shuts off the engine if the operator leaves the seat with the mower running and the speed control is not in the neutral postion with the parking brake applied. It will also shut off the engine if the hopper is raised with the cutter deck drive engaged. Never operate equipment with the interlock system disconnected or malfunctioning.
8.Be sure interlock switches are functioning correctly.
9.Fuel is flammable; handle with care. Fill fuel tank outdoors. Never fill indoors. Use a funnel or spout to inhibit spillage. Clean up any spillage before starting the engine.
10.DO NOT add fuel to a running or hot engine. An explosion could occur. Allow engine to cool for several minutes before adding fuel.
11.Keep flammable objects (cigarettes, matches, etc.), open flames and sparks away from the fuel tank and fuel container.
5
2.4 OPERATION CONSIDERATIONS
1.Know the function of all controls and how to stop quickly.
2.Reduce speed and exercise extreme caution on slopes and in sharp turns to prevent tipping or loss of control. Be especially cautious when changing directions on slopes.
WARNING:
DO NOT operate on steep slopes.To check a slope, attempt to drive up it (with cutter deck down). If machine can drive up the slope without the wheels slipping, reduce speed and use extreme caution.
ALWAYS FOLLOW OSHA APPROVED OPERATION.
3.Do not stop or start suddenly. WHEN MOWING A
HILLSIDE, MOW UP AND DOWN THE FACE OF SLOPES, NEVER ACROSS THE FACE.
4.When using any attachment, never direct the discharge of material toward bystanders or allow anyone near the machine while in operation.