Land PrideTable of Contents
Section 5: Maintenance and Lubrication
2-Plate Disassembly
Step 1
Remove snap ring.
Step 2
Remove backup ring, lock collar, compression spring, bottom backup ring, and balls.
Step 3
Tighten the four hex nuts uniformly until the clutch pack and hub are loose.
Step 4
Bend all four retaining lugs out on edge of clutch housing.
Step 5
Remove thrust plate with Belleville Springs and lug rings to access friction discs and hub for inspection or service.
Step 6
Inspect friction discs and hub.
10435 | 10449 |
2-Plate Assembly
Step 1
Place hub and friction discs into the housing.
Step 2
Compress Belleville Springs to the pressure plate by tightening the four hex nuts and then placing the assembly into the clutch housing.
Step 3
Bend retaining lugs inward over the Belleville Spring edges to secure the spring before backing the four hex nuts off.
Step 4
With lugs bent in, loosen the four hex nuts completely to the end of the threaded studs.
Step 5
Insert greased balls.
Step 6
Install bottom backup ring, compression spring, lock collar, and top backup ring.
Step 7
Install snap ring.
11/14/08 | AFM4211 | 27 |