Land Pride AFM4211 manual Introduction, Joint Timing, Transporting

Page 18

Table of Contents

Section 2: Operating Instructions

Land Pride

Introduction

Hazard control and accident prevention are dependent upon the awareness, concern, prudence and proper training involved in the operation, transport, maintenance and storage of the Grooming Mower. Therefore, it is absolutely essential that no one operates the mower without first having read, fully understood and become totally familiar with the Operator’s Manual. Make sure the operator has paid particular attention to:

Important Safety Information, pages 1 to 10

Section 1: Assembly and Set-up,page 12

Section 2: Operating Instructions, page 16

Section 3: Adjustments, page 20

Section 5: Maintenance and Lubrication, page 23

Hazard control and accident prevention are dependent upon the awareness, concern, prudence and proper training involved in the operation, transport, maintenance and storage of the mower.

IMPORTANT: Do not alter the Grooming Mower in a way which will adversely affect its performance or reliability or use the mower for a purpose for which it was not designed.

!DANGER!

Before making adjustments or performing maintenance on your mower, disengage PTO, shut off tractor and wait for all moving parts to stop before dismounting tractor. Disconnect the PTO driveline.

U-Joint Timing

Refer to Refer to Figure 2-1:

Transporting

!WARNING!

Do not transport mower faster than 20 mph. When traveling on roadways, transport in such a manner that vehicles moving at a faster rate of speed may pass you safely.

!CAUTION!

Care should be taken when encountering oncoming traffic and roadside obstructions if the mower is wider than your tractor.

!CAUTION!

Always disengage tractor PTO before raising the Grooming Mower to transport position to avoid damaging the mower, injury from thrown objects or blade contact.

!CAUTION!

When traveling on public roads, whether at night or during the day, use accessory lights and devices for adequate warning to operators of other vehicles. Comply with all federal, state, and local laws.

Be sure to reduce tractor ground speed when turning; and, leave enough clearance so the mower does not contact obstacles such as buildings, trees or fences.

Select a safe ground travel speed when transporting from one area to another. When traveling on roadways, transport in such a way that faster moving vehicles may pass you safely.

When traveling over rough or hilly terrain, shift tractor to a lower gear.

Refer to Figure 2-2:

!CAUTION!

On mowers equipped without slip clutches the deck drivelines (3 each) must be in time to avoid driveline damage when folding - unfolding

.

1.Raise the 3 mower decks to the transport position by retracting all 3 cylinders completely.

2.As the mower decks are raising, the transport locks (3 each) will automatically lock in place when operating properly.

Spring Loaded

Transport Locks

U-Joint Timing

Figure 2-1

Pull Rope

13660

 

Pull Ropes

Figure 2-2

16 AFM4211 All-Flex Mowers 315-507M

11/14/08

Image 18
Contents All-Flex Mowers Table of Contents Safety at All Times Use a Safety Chain Practice Safe MaintenanceTransport Machinery Safely Avoid High Pressure Fluids Hazard Tire SafetyWear Protective Equipment Keep Riders Off MachinerySafety Labels 818-339C818-019C 818-561C818-337C 818-130C818-552C 818-556C 818-045C818-555C 838-270C 818-003C838-345C 818-543C0818-187C 818-229C 818-230C818-540C Using This Manual ApplicationOwner Assistance PTO To Drawbar Set-Up Tractor RequirementsHardware Torque Information Tractor Hook-upMain Driveline Installation Check Constant Velocity Driveline LengthDriveline Shortening Gauge Wheel Assembly Hydraulic Hook-upPull Rope Hook-up Bleeding Hydraulics Transport Fold Hydraulic PlumbingTransporting IntroductionJoint Timing Joint TimingConstant Velocity Driveline Angle Pre-Operation InstructionsOperating Instructions Table of Contents Center Deck Height Adjustments Cutting Height ChartBelt Tension Accessory Part Numbers Ball Swivel HitchCutting Blades Servicing Mower Blades MaintenanceBlade Placement Blade InspectionBlade Removal And Installation Blade RotationBlade Removal Blade Options Belt InstallationBlade Sharpening Blade SharpeningType a Clutches Clutch Run-In Clutch Disassembly, Inspection & AssemblyDriveline Protection Clutch TypesPlate Disassembly Step Plate Assembly StepType B Clutch Clutch Run-In Disassembly and AssemblyType B Clutch Assembly Hex Head Socket BoltsStorage Tires With Air PressureDriveline Constant Velocity Shaft LubricationHours Driveline ShaftsWheel Bushings Transport Hubs Wheel Support BushingsWheel Bushings Gauge Wheels Blade Spindle Bearings, Center DeckMower Deck Gearbox RequiredWay Gearbox Blade Spindle Bearings, Wing DecksRear Deck Pivot Half Clamps Transport LocksWing Deck Pivot Bushings Wing Flex Pivot LugsSpecification / Capacity AFM4211 All-Flex Grooming MowersTable of Contents Features Benefits Problem Cause Solution Patches of uncut grass Discharge openings pluggedBelt slipping Gearbox noisyTorque Values Chart Tire Inflation ChartAdditional Torque Values 40 AFM4211 All-Flex Mowers 315-507M Warranty Overall Unit and Drivelines One year Parts and LaborCorporate Office P.O. Box 5060 Salina, Kansas 67402-5060 USA
Related manuals
Manual 82 pages 29.47 Kb