ENGLISH
!0Subwoofer Output
Connect this jack to the line level input of a powered subwoofer. If an external subwoofer amplifier is used, connect this jack to the subwoofer amplifier input. If you are using two subwoofers, either powered or with a 2 channel subwoofer amplifier, connect a “Y” connector to the subwoofer output jack and run one cable from it to each subwoofer amplifier.
!17.1 CHANNEL or AUX2 INPUT
By connecting a DVD Audio player, SACD multichannel player, or other components that has a multichannel port, you can playback the audio with 5.1 channel or 7.1 channel outputs.
!2Multiroom Outputs (SR5001 only)
These are the audio output jacks for the Multi zone (Multi room).
Connect these jacks to optional audio power amplifiers to listen the source selected by the multiroom system in a remote room.
!3REMOTE CONT. IN/OUT terminals
Connect to a Marantz component equipped with remote control
!4AUDIO IN/OUT (CD, TAPE, CD-R,
TV, DVD, VCR1, DSS/VCR2)
These are the analog audio inputs and outputs. There are 7 audio inputs (4 of which are linked to video inputs) and 4 audio outputs (2 of which are linked to video outputs). The audio jacks are nominally labeled for cassette tape decks, compact disc players, DVD players and etc.... The audio inputs and outputs
require
!5DIGITAL INPUT
(SR4001 : Dig.1 - 4, SR5001 : Dig.1-5) / OUTPUT (coaxial, optical)
These are the digital audio inputs and outputs. There are 2 digital inputs with coaxial jacks, 2 with optical jacks.
The inputs accept digital audio signals from a CD, DVD, or other digital source component.
For digital output, there is 1 coaxial output and 1 optical output.
The digital outputs can be connected to MD recorders, CD recorders, or other similar components.
!6HDMI INPUT/OUTPUT
This unit has 2 HDMI inputs and 1 HDMI output. The input function can be selected from the OSD menu system. (See page 25)
!7DC TRIGGER output terminal (SR5001 only)
Connect a device that needs to be triggered by DC under certain conditions (screen, power strip, etc…) Use the system OSD setup menu to determine the conditions by which these jack will be active.
Note:
This output voltage is for (status) control only, It is not sufficient for drive capability.
!8FLASHER IN
(Flasher input terminal) (SR5001 only)
These terminals are to control the unit from each zone. Connect the control signal from a Keypad, etc.
!9SPEAKER C SELECTOR SWITCH (SR5001 only)
The terminals can be used to connect a third set of speakers by setting the SPEAKER C selector switch to ON. For connection and use, see page 22.
8