Generac Power Systems 005053-1, 005054-0 Your Warranty Rights And Obligations, Whitewater, Wi

Page 54
Section 10 – Warranty

Section 10 – Warranty

Guardian Liquid-cooled 25 kW Generator

CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The California Air Resources Board (CARB) and Generac Power Systems, Inc. (Generac) are pleased to explain the Emission Control System Warranty on your new engine.* In California, new utility, and lawn and garden equipment engines must be designed, built and equipped to meet the state’s stringent anti-smog standards. Generac will warrant the emission control system on your engine for the periods of time listed below provided there has been no abuse, neglect, unapproved modifi- cation or improper maintenance of your engine.

Your emission control system may include parts such as the carburetor, ignition system and exhaust system. Generac will repair your engine at no cost to you for diagnosis, replacement parts and labor, should a warrantable condition occur.

MANUFACTURER’S EMISSION CONTROL SYSTEM WARRANTY COVERAGE:

Emissions control systems on 1995 and later model year engines are warranted for two years as hereinafter noted. If, dur- ing such warranty period, any emission-related component or system on your engine is found to be defective in materials or workmanship, repairs or replacement will be performed by a Generac Authorized Warranty Service Dealer.

PURCHASER’S/OWNER’S WARRANTY RESPONSIBILITIES:

As the engine purchaser/owner, you are responsible for the completion of all required maintenance as listed in your factory supplied Owner’s Manual. For warranty purposes, Generac recommends that you retain all receipts covering maintenance on your engine. However, Generac cannot deny warranty solely due to the lack of receipts or for your failure to ensure the completion of all scheduled maintenance.

As the engine purchaser/owner, you should, however, be aware that Generac may deny any and/or all warranty coverage or responsibility if your engine, or a part/component thereof, has failed due to abuse, neglect , improper maintenance or unap- proved modifications, or the use of counterfeit and/or “grey market” parts not made, supplied or approved by Generac.

You are responsible for presenting your engine to a Generac Authorized Warranty Service Dealer as soon as a prob- lem occurs. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

Warranty service can be arranged by contacting either your selling dealer or a Generac Authorized Warranty Service Dealer. To locate the Generac Authorized Warranty Service Dealer nearest you, call our toll-free number:

1-800-333-1322

IMPORTANT NOTE: This warranty statement explains your rights and obligations under the Emission Control System Warranty (ECS Warranty), which is provided to you by Generac pursuant to California law. See also the “Generac Power Systems, Inc., Two Year Limited Warranty” which is enclosed herewith on a separate sheet, also provided to you by Generac. The ECS Warranty applies only to the emission control system of your new engine. If there is any conflict in terms between the ECS Warranty and the Generac Warranty, the ECS Warranty shall apply except in circumstances where the Generac Warranty may provide a longer warranty period. Both the ECS Warranty and the Generac Warranty describe important rights and obligations with respect to your new engine.

Warranty service can be performed only by a Generac Authorized Warranty Service Dealer. When requesting warranty serv- ice, evidence must be presented showing the date of the sale to the original purchaser/owner.

If you have any questions regarding your warranty rights and responsibilities, you should contact Generac at the fol- lowing address:

ATTENTION WARRANTY DEPARTMENT

GENERAC POWER SYSTEMS, INC.

P.O. BOX 297

WHITEWATER, WI 53190

Part 1

52 Generac® Power Systems, Inc.

Image 54
Contents Liquid-cooled, Prepackaged Standby Generators SHOULD ATTEMPT INSTALLATIONOwner’s Manual This manual should remain with the unit‹ HOW TO OBTAIN SERVICE AUTHORIZED SERVICE DEALER LOCATION‹ OPERATION AND MAINTENANCE INTRODUCTIONTable of Contents Guardian Liquid-cooled 25 kW GeneratorParts of the generator are rotating and/or hot GENERAL HAZARDSDespite the safe design of this generator during operation. Exercise care near running gen- eratorsEXPLOSION HAZARDS ELECTRICAL HAZARDSFIRE HAZARDS ‹ STANDARDS INDEX1.3 AUTOMATIC SYSTEM OPERATION 1.2 TRANSFER SWITCH1.1 GENERATOR 1.4 GENERATOR AC CONNECTION SYSTEMS‹ 1.7.3 LOW COOLANT LEVEL SWITCH ‹ 1.7.1 LOW OIL PRESSURE SWITCH‹ 1.7.2 HIGH COOLANT TEMPERATURE SWITCH Figure 1.4 - Low Oil Pressure Switch‹ 1.8.1 UNPACKING PRECAUTIONS 1.10 SPECIFICATIONS‹ 1.7.6 LOW BATTERY 1.8 UNPACKING1.11 FUEL CONSUMPTION 1.12 RECONFIGURING THE FUEL SYSTEM FOR LP VAPORFigure 1.8 - Reconfigure the Fuel System ‹ 1.10.2 GENERATOR1.13 ENGINE OIL RECOMMENDATIONS 1.15 BEFORE INSTALLATION2.1 STANDBY GENERATOR INSTALLATION 1.14 COOLANT RECOMMENDATIONS2.2 GENERATOR LOCATION 2.3 GENERATOR MOUNTING AND SUPPORT2.4 BASIC STANDBY ELECTRIC SYSTEM ‹ 2.1.2 OTHER PUBLISHED STANDARDS2.6 TOTAL CIRCUIT ISOLATION METHOD 2.9 USING AN ENGINEERED “GTS” TRANSFER SWITCH2.5 EMERGENCY CIRCUIT ISOLATION METHOD 2.7 GROUNDING THE GENERATOR‹ 2.10.1 VENTED BATTERIES 2.10 BATTERY INSTALLATIONPos2 OFF - Standard Prepackaged ATS Application Standby generators installed with automatic2.11 PREPARATION BEFORE START-UP 3.1 ENGINEERED GTS TRANSFER SWITCH‹ 2.11.2 TRANSFER SWITCH ‹ 2.11.1 PRIOR TO INITIAL START-UP‹ 3.2.5 SET EXERCISE TIME SWITCH ‹ 3.2.2 FAULT INDICATOR LEDS‹ 3.2.1 AUTO/OFF/MANUAL SWITCH 3.2 CONTROL CONSOLE COMPONENTS3.4 ENGINE GOVERNOR ADJUSTMENTS 3.3 MANUAL TRANSFER AND START-UP‹ 3.2.6 SYSTEM READY LED 3.6 AUTOMATIC OPERATION Figure 3.2 - Engine Governor AdjustmentFigure 3.3 - “Set Exercise Time” Switch 3.7 WEEKLY EXERCISE CYCLEA. EVERY THREE MONTHS 3.8 CONTROL BOARD DIP SWITCH SETTINGS4.1 MAINTENANCE PERFORMED BY AUTHORIZED SERVICE FACILITIES B. ONCE EVERY SIX MONTHS4.4 CYLINDER HEAD PROCEDURE 4.2 EXHAUST MANIFOLD PROCEDURE4.3 INTAKE MANIFOLD PROCEDURE Figure 4.1 - Intake Manifold Installation4.8 MAINTENANCE OWNER/ OPERATOR CAN PERFORM 4.6 OVERLOAD PROTECTION FOR ENGINE DC ELECTRICAL SYSTEM4.7 CHECKING FLUID LEVELS ‹ 4.8.8 CHECK FAN BELT ‹ 4.8.11 CHANGING THE ENGINE AIR CLEANERFigure 4.4 - Setting the Spark Plug Gap ‹ 4.8.9 INSPECT ENGINE GOVERNOR‹ 4.9.2 BATTERY 4.9 MISCELLANEOUS MAINTENANCE‹ 4.9.1 CLEANING THE GENERATOR ‹ 4.9.3 BATTERY MAINTENANCETurn off the battery charger turn OFF utility supply to ATS 4.10 SCHEDULED MAINTENANCEService Maintenance Interval Information Remove the negative battery cableMaintenance LevelTasks Maintenance CAUSE TROUBLESHOOTING POINTSPROBLEM CORRECTIONGenerac Power Systems, Inc Wiring Diagram - 2.5L Engine 15kW & 20kW units -Drawing No. 0F1411 26 Generac Power Systems, IncSection 7 - Electrical Data Generac Power Systems, Inc 28 Generac Power Systems, Inc Generac Power Systems, Inc Wiring Diagram - 2.5L Engine 25kW unit -Drawing No. 0E9982-B 30 Generac Power Systems, IncGenerac Power Systems, Inc Electrical Schematic - 2.5L 25kW unit - Drawing No. 0E9983-B 32 Generac Power Systems, IncGenerac Power Systems, Inc MOUNT HARNESS WIRE34 Generac Power Systems, Inc BLOCK ENGINEDESCRIPTION COVER CABLE PANEL FOR ACCESSGROUND WIRE FASTENER TO SECUREEnclosure - Drawing No. 0E9720-D 38 Generac Power Systems, Inc HINGE CONTINUOUS 1.5L CTRL PNL 40 Generac Power Systems, Inc DESCRIPTION STEPPER MOTOR UNITS ONLY 42 Generac Power Systems, IncGuardian Liquid-cooled 25 kW Generator Engine - Drawing No. 0E9918-E TO RADIATORSERPENTINE BELT - 41 3/8 LENGTH SOURCE GENERAC-BOSCH GOVGASKET, 2.5L FORD EXHAUST MAN BRKT,D.C. ALTERNATORMACHINEDCOVER 0E1028A I/NTO ENGINE 44 Generac Power Systems, IncGuardian Liquid-cooled 25 kW Generator 46 Generac Power Systems, Inc LOCKTIGHTLEADS Alternator - Drawing No. 0E8660-CSTR 390 35AD1 HSB 382MM LONG3.0L FORD & 2.5L FORD ROTOR REPLACEMENT PARTSROTOR 390 30KW 1P DIRECT HSB 3.0L FORD & 2.5L FORD CONDUIT FLEX 1-1/4 30 LG - 3.0L FORD & 3.9L CHRYSLER48 Generac Power Systems, Inc SCREW HHC M8-1.25 X 60 G8.8 FTCOATING SECURE WIRE HARNESSITEM 13 NEOPRENE WITH TIE WRAP AS SHOWNSUPPORT,RADIATOR 2.5L FORD 50 Generac Power Systems, Inc1024 HOSE, UPPER RADIATOR 174MMSection 9 - Installation Diagram Installation Diagram - Drawing No. 0F1020-APURCHASER’S/OWNER’S WARRANTY RESPONSIBILITIES YOUR WARRANTY RIGHTS AND OBLIGATIONSMANUFACTURER’S EMISSION CONTROL SYSTEM WARRANTY COVERAGE CALIFORNIA EMISSION CONTROL WARRANTY STATEMENTEMISSION CONTROL SYSTEM WARRANTY EMISSION RELATED PARTS INCLUDE THE FOLLOWINGTHIS WARRANTY SHALL NOT APPLY TO THE FOLLOWING GENERAC POWER SYSTEMS TWO YEAR LIMITED WARRANTY FOR GUARDIANWARRANTY SCHEDULE GENERAC POWER SYSTEMS, INC P.O. BOX 297 WHITEWATER, WI