| SPECIFICATIONS | |
|
| Model ZTR 5020 |
CHASSIS: | 11 GA - rectangular tube | |
BODY: | Two piece - made of rotational molded polyethylene. Front body contains access panels for | |
| battery service and engine to mower deck belt removal. Rear body tilts up to allow service on | |
| the entire drive system. | |
SEAT: | Designed for operator comfort by use of high density closed cell foam padded back rest and | |
| arm rests, upholstered with CorduraTM | |
MOWER DECK: | 2 Decks are available. 60" is made of stamped steel. 50" is made of 11 GA fabricated welded | |
| construction with external reinforcement ribs. 3 blades combine for either a 50" or 60" cut | |
| width. Cut height approximately 1.5" to 4.5" via 7 position lift handle. | |
BLADE DRIVE: | Electric clutch | |
DRIVE SYSTEM: | Each rear wheel is independently driven by a HydroGear | |
| transmission. The hydrostatic transmissions, in turn, power a fully enclosed HydroGear | |
| gearbox. |
|
ENGINE: | 20HP Briggs & Stratton Intek, overhead valves, replaceable oil filter, full pressure lube | |
| system, dual element air cleaner, integral fuel pump. | |
STARTING SYSTEM: | Electric by key switch operation with safety interlocks on parking brake and blade drive | |
| clutch. |
|
TIRES: | Front | 11 X 4 X 5 Ribbed Tread |
| Rear | 20 X 10 X 8 Multi Trac |
RECOMMENDED | Front | 16 - 21 lbs. |
TIRE PRESSURE: | Rear | 8 - 14 lbs. |
CAPACITIES: | Fuel - 4.8 gallons total (dual tanks) | |
| Hydrostat oil tank - 3 quart with | |
| Hydrostat oil recommendation, refer to page 39 | |
| Engine - 2 qts. SAE 30 (with filter) | |
DIMENSIONS: | Width | 60"(50" Deck), 73"(60"Deck) |
| Height | 45" |
| Length | 72" |
| Weight | 668 lbs. (50" Deck), 685 lbs. (60" Deck) |
NOTE: | Additional information provided in service instructions under the individual component. | |
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Page 11