Dixon ZTR 5017Twin manual Chassis

	SPECIFICATIONS
		Model ZTR 5023
CHASSIS:	11 GA - rectangular tube
BODY:	Two piece - made of high-density polyethylene. Front body contains access panels for
	battery service and engine to mower deck belt removal. Rear body tilts up to allow service on
	the entire drive system.
SEAT:	Designed for operator comfort by use of high density closed cell foam padded back and arm
	rests, upholstered with CorduraTM water-repellent fabric. Seat is adjustable fore and aft.
MOWER DECK:	2 Decks are available. 60" is made of stamped steel. 50" is made of 11 GA fabricated welded
	construction with external reinforcement ribs. 3 blades combine for either a 50" or 60" cut
	width. Cut height approximately 1.5" to 4.5" via 7 position lift handle.
BLADE DRIVE:	Electric clutch
DRIVE SYSTEM:	Each rear wheel is independently driven by a HydroGear BDU-10L Series 70 hydrostatic
	transmission. The hydrostatic transmissions, in turn, power a fully enclosed HydroGear
	gearbox.
ENGINE:	23HPKohlerCommand,4-Cycle,V-Configuration,OverheadValve,Air-Cooled,Gasoline,
	Vertical Shaft, Aluminum Head, and Crankcase with Cast Iron Liners, Full Pressure
	Lubrication/Full Flow Filter, Pulse-type Fuel Pump, Fixed Jet Carburetor w/Smart-Choke,
	Electronic Ignition, In-Line Fuel Filter, Dual Element Air Cleaner.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks on parking brake and blade drive
	clutch.
TIRES:	Front	11 X 4 X 5 Ribbed Tread
	Rear	20 X 10 X 8 Multi Trac
RECOMMENDED	Front	16 - 21 lbs.
TIRE PRESSURE:	Rear	8 - 14 lbs.
CAPACITIES:	Fuel - 4.8 gallons total (dual tanks)
	Hydrostat oil tank - 3 quart with in-line 40 micron filter
	Hydrostat oil recommendation, refer to page 39
	Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS:	Width	60"(50" Deck), 72"(60" Deck)
	Height	45"
	Length	72"
	Weight	680 lbs.(50" Deck), 685 lbs.(60" Deck)
NOTE:	Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 12