Dixon manual Model ZTR 5017Twin

	SPECIFICATIONS
		Model ZTR 5017Twin
CHASSIS:	11 GA - rectangular tube
BODY:	Two piece - made of rotational molded polyethylene. Front body contains access panels for
	battery service and engine to mower deck belt removal. Rear body tilts up to allow service on
	the entire drive system.
SEAT:	Designed for operator comfort by use of high density closed cell foam padded back rest and
	arm rests, upholstered with CorduraTM water-repellent fabric. Seat is adjustable fore and aft.
MOWER DECK:	2 Decks are available. 42" is constructed of 13 ga stamped steel. 50" is a fabricated deck. 3
	blades combine for either a 42" or 50" cut width. cut width. Cut height approximately 1.5"
	to 4.5" via 7 position lift handle.
BLADE DRIVE:	Electric clutch
DRIVE SYSTEM:	Each rear wheel is independently driven by a HydroGear BDU-10L Series 70 hydrostatic
	transmission. The hydrostatic transmissions, in turn, power a fully enclosed HydroGear
	gearbox.
ENGINE:	17HP Briggs & Stratton V-Twin, overhead valves, replaceable oil filter, full pressure lube
	system, dual element air cleaner, integral fuel pump.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks on parking brake and blade drive
	clutch.
TIRES:	Front	11 X 4 X 5 Ribbed Tread
	Rear	18 X 9.5 X 8 Multi Trac
RECOMMENDED	Front	16 - 21 lbs.
TIRE PRESSURE:	Rear	8 - 14 lbs.
CAPACITIES:	Fuel - 4.8 gallons total (dual tanks)
	Hydrostat oil tank - 3 quart with in-line 40 micron filter
	Hydrostat oil recommendation, refer to page 39
	Engine - 2 qts. SAE 30 (with filter)
DIMENSIONS:	Width	54" (42" Deck), 60" (50" Deck)
	Height	45"
	Length	72"
	Weight	615 lbs (42" Deck), 668 (50" Deck)
NOTE:	Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 13