5.When correct Press and release the ENTER button 
to switch to Batt_Type flashing.
6.Press and release the FWD/+ button 
to switch to another menu choice, or press and release the 
MENU/STORE button to write the menu change(s) and return to stop mode.
Remote Mode
Use a wired remote, not supplied, to control the PMD670. There are four remote modes:
•StartStop – during recording or playback switch the remote off to pause, on to resume.
•EDL Mark – during recording or playback switch remote to on to add an EDL mark.
•PWR REC – during power off, switch remote to on to turn power on and begin recording. During recording switch remote to off to stop recording and power off.
•M.Track – during recording, switch remote to on to increment the track. A new track is created at that point.
Default is StartStop.
1. Select the RemoteMode menu choice:
a.From stop, press and hold the 
MENU button for about 2 seconds. MENU will appear (flashing) in the display.
b.While MENU is flashing (for about 3 seconds) press and release the ENTER button 
. The last Menu choice selected will appear. (If the flashing MENU times out start over at a.)
2.Press and release the FWD/+ button 
repeatedly until RemoteMode is displayed and flashing.
3.Press and release the ENTER button 
to accept the RemoteMode choice and switch to RemoteMode choices.
4.Press and release the FWD/+ button 
or the 
to tab through the RemoteMode choices: StartStop, EDL Mark, PWR REC, or M.Track
5.When correct Press and release the ENTER button 
to switch to RemoteMode flashing.
6.Press and release the FWD/+ button 
to switch to another menu choice, or press and release the 
MENU/STORE button to write the menu change(s) and return to stop mode.
Broadcast Wave ID numbers
Broadcast Wave Format (.bwf) has three identifi- cation numbers in the header (Extension Chunk): Description, Originator, and Originator Refer- ence.
For example, if the IDs are used for a broadcast station ID1 could be the identifier of the station, ID2 could be used for the department code, and ID3 for the badge number of the reporter.
Default is all ID number at 000000.
1. Select the ID1 menu choice:
a.From stop, press and hold the 
MENU button for about 2 seconds. MENU will appear (flashing) in the display.
b.While MENU is flashing (for about 3 sec- onds) press and release the ENTER button 
. The last Menu choice selected will appear.
(If the flashing MENU times out start over at a.)
2.Press and release the FWD/+ button 
repeatedly until ID1 is displayed and flashing.
- 36 -