Black & Decker LSWV36R Charging Procedure, Charger Diagnostics, Bad battery, Hot/Cold pack delay

Page 6

•Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

•Charge the battery packs only in Black & Decker chargers.

•DO NOT splash or immerse in water or other liquids. This may cause premature cell failure.

•Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in summer).

WARNING: Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert

into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

WARNING: Fire hazard. Do not store or carry battery so that metal objects can contact exposed battery terminals. For example, do

not place battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc., with loose nails, screws, keys, etc. Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e., packed in suitcases and carry-on luggage) UNLESS they are properly protected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit.

NOTE: LI-ION batteries should not be put in checked baggage. Storage Recommendations

1. The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold.

2. Long storage will not harm the battery pack or charger.

Charging Procedure

The standard charger provided will charge a fully depleted battery in

about 2 hours. A 80% charge is available in 1 hour.

1. Plug the charger into an appropriate outlet before inserting the

battery pack.

 

2. Insert the battery pack into the charger as shown in figure A.

 

 

 

3. The green LED (figure A1) will flash indicating that the battery

 

 

 

 

 

is being charged.

 

 

 

 

A

 

 

 

4. The completion of charge is indicated by the

 

 

 

 

 

 

green LED (figure A1) remaining on continuously.

 

 

 

 

 

 

 

 

The pack is fully charged and may be used at this

 

 

 

 

time or left on the charger.

A1

Recharge discharged batteries as soon as

possible after use or battery life may be

 

greatly diminished.

 

Charger Diagnostics

 

This charger is designed to detect certain

 

problems that can arise with the battery packs

 

or the power source. Problems are indicated by one LED (figure A1)

flashing in different patterns.

 

Bad battery

The charger can detect a weak or damaged battery. The red LED flashes in the pattern indicated on the label. If you see this bad battery blink pattern, do not continue to charge the battery. Return it to a service center or a collection site for recycling.

Hot/Cold pack delay

When the charger detects a battery that is excessively hot or excessively cold, it automatically starts a Hot/Cold Pack Delay, suspending charging

until the battery has normalized. After this happens, the charger automatically switches to the Pack Charging mode. This feature ensures maximum battery life. The red LED flashes in the pattern indicated on the label when the hot / cold pack delay is detected.

Leaving the battery in the charger

The charger and battery pack can be left connected with the green

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Save this manual for future reference VEA EL ESPA-OL EN LA ContraportadaPour LE FRANÇAIS, Voir LA Couverture ARRIÈre Table of Contents Important Safety warnings & instructionsGeneral safety warnings and instructions for all tools Do not attempt to charge the battery pack with any chargers Important safety instructions For battery chargersLSWV36 Power Head ComponentsImportant safety instructions For battery Packs Recommended Minimum Wire Size for Extension CordsBad battery Charging ProcedureCharger Diagnostics Hot/Cold pack delayInstalling and Removing the Battery Pack Sweeper Mode assembly Tube assemblyFan Cover assembly To attach Operation Sweeper operationParts. this Sweeper is for With a small wooden stick. Do not use a metal implement or VacUUM operationWhat to do if the unit jams Figure M Actions that may lead to the unit jamming areHow to avoid jamming the unit MaintenanceAccessories Cleaning and StorageTRoubleshooting Problem SolutionService Information Full Three-Year Home Use WarrantyNuméro de catalogue LSWV36 Directives ET Avertissements DE Sécurité Importants Table DES MatièresDéfinitions Graves blessuresGénérales Pour Tous LES Outils Lire et respecter toutes les mesures de sécuritéUniquement des pièces de rechange Black & Decker Composantes Avertissement risque de choc électriqueCalibre de fil minimum recommandé pour les rallonges Tenir le cordon éloigné des surfaces chaufféesProtéger le chargeur de la pluie et de la neige Directives de sÉcuritÉ importantes pour Les blocs-piles NE Jamais tenter de relier deux chargeurs ensembleProcédure de charge Recommandations en matière de rangementFonctions de diagnostic du chargeur Pile en mauvais étatRemarques importantes pour le chargement Indicateur de L’état De charge figure BPile laissée dans le chargeur Indicateur DE L’ÉTAT DE Charge Figure BInsertion DU BLOC-PILES Assemblage DU Mode BalayeuseInsertion et retrait du bloc-piles SAC Collecteur Figure DInterrupteur FonctionnementFonctionnement DE LA Balayeuse Le sac avant de réutiliser l’appareilActions Pouvant Entraîner LE Blocage DE L’APPAREIL AccessoiresEntretien Comment Éviter LE Blocage DE L’APPAREILDEpannage Page Modelo N LSWV36 Advertencias E Instrucciones ÍndicePautas DE SEGURIDAD/DEFINICIONES Importantes DE SeguridadTenga Mucho Cuidado cuando limpie en escalones 30 Guárdese bajo techoComponentes No exponga el cargador a la lluvia ni a la nieve Conserve Estas InstruccionesRecomendaciones con respecto al almacenamiento Retraso por paquete caliente/frío Procedimiento de cargaBatería en mal estado Dejar la batería en el cargadorEnsamblaje EN Modo DE Barredora IndicaDOr deL Estado de la carga figure BInstalación y extracción del paquete de La carga. Éste no indica la capacidad deBolsa DE Recolección Figura D Ensamblaje EN Modo DE AspiradoraOperación Ensamblaje DEL Tubo Aspirador Figuras E, F Y GPiezas en movimiento. Esta Barredora Anteojos de seguridad. Use unaRopa holgada lejos de las aberturas y las Nota Asegúrese de que la barredoraMantenimiento Cómo Evitar LA Obstrucción DE LA UnidadLimpieza Y Almacenamiento Información de mantenimiento Detección de problemasAccesorios El sello RbrcGarantía completa de tres años para Uso en el hogar Solamente para Propósitos de MéxicoPage Page Page Solamente Para Propositos DE Mexico

LSWV36, LSWV36R specifications

The Black & Decker LSWV36 and LSWV36R are versatile cordless leaf blowers that embody efficiency and convenience for outdoor maintenance. These models provide exceptional power in a lightweight design, making them ideal for homeowners looking to keep their yards tidy without the hassle of cords or gas.

One of the standout features of the LSWV36 and LSWV36R is the 36-volt lithium-ion battery. This technology ensures longer run times and faster charging, allowing users to complete their tasks without frequent interruptions. The battery delivers consistent power, ensuring that the blower operates at peak performance until the charge is exhausted. Users can expect up to 30 minutes of runtime on a single charge, which is generally sufficient for most residential lawns.

Both models boast a powerful wind speed of up to 120 mph, allowing for efficient leaf removal and debris clearance from sidewalks, driveways, and patios. The lightweight and ergonomic design of the blowers makes them easy to maneuver, reducing arm fatigue during extended use. Weighing approximately 7.5 pounds, these leaf blowers are manageable for users of all ages.

The LSWV36 and LSWV36R come equipped with two speed settings, providing the flexibility to tackle different tasks. The lower speed setting is perfect for clearing grass clippings, while the higher speed is ideal for moving stubborn leaves and heavier debris. This feature ensures that users have control over the tool's performance, adapting to the specific needs of their outdoor spaces.

Moreover, the LSWV36R model features a vacuum and mulching system, which adds to its versatility. Users can easily switch from blowing leaves to vacuuming them up, transforming yard waste into mulch for composting or garden use. This dual functionality not only saves time but also assists in creating an eco-friendly gardening solution.

In summary, the Black & Decker LSWV36 and LSWV36R deliver powerful performance, runtime efficiency, and dual functionality, making them indispensable tools for maintaining a clean and orderly yard. They combine innovative technology with user-friendly features, providing an excellent solution for anyone seeking a reliable cordless leaf blower. Whether blowing leaves or mulching yard waste, these models are sure to exceed expectations.
Top Page Image Contents