Black & Decker LSWV36R manual Sweeper Mode assembly, Tube assembly, Fan Cover assembly To attach

Page 8

SWEEPER MODE assembly

 

NOTE: Ensure the sweeper is switched off and the battery is

 

removed before attaching or removing the sweeper tubes. The

•

tube assembly must be assembled to the housing before use.

tube assembly:

D

 

 

To attach the two piece

 

 

sweeper tubes to the

 

 

 

sweeper, line up the tube

 

 

 

with the sweeper housing

 

 

 

as shown in figure D. Push

 

 

 

the tube into the sweeper

 

D1

 

housing until the lock lever engages the

•

lock hole in the tube.

 

 

Fan Cover assembly: To attach the

 

 

fan cover to the sweeper, line up the tabs

 

 

on the cover with the sweeper housing

 

 

slots as shown in figure D1. Push the

 

 

cover into the sweeper housing until the

 

 

locking/release button is fully engaged.

 

(This comes pre-assembled from the factory).

 

VACUUM MODE ASSEMBLY

Vacuum Tube Assembly (FigURES F, G, H, H1)

NOTE: Ensure the sweeper is switched off and the battery is removed before attaching or removing the vacuum tubes. The vacuum tube and collection bag must be assembled to the housing before use.

• Vacuum tubes must be assembled together before use.

• Align the notches and the triangles on upper and lower tubes. (figure F)

• Push the lower tube firmly into the upper tube, until the triangles click into place. (Never operate apart).

• In the interest of safety, it is not intended for the tubes to be separated once assembled.

• Remove the fan cover from the side of the sweeper housing by pressing the spring loaded release button (located on the lower right side of the sweeper housing) and pulling the cover off (figure G). Fan cover can be stored in pouch on collection bag.

F

G

H

Collection Bag (FigURE E)

• Remove sweeper tube if attached.

• Push the collection bag on to the sweeper housing until the lock lever engages the lock hole as shown in figure E.

• Attach collection bag clip to the lower rear of the unit as shown in figure E1.

E

E1

• Attach the vacuum tube assembly to the fan inlet on the sweeper housing (figure H) by lining up the tabs on the tube with the slots on the sweeper housing and push inwards until the locking/release button is fully engaged.

(figure H1)

• Vacuum tube assembly can be stored by hanging on a wall with a nail, using the built in hang hole on the underside of the tube.

8

H1

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Pour LE FRANÇAIS, Voir LA Couverture ARRIÈre Save this manual for future referenceVEA EL ESPA-OL EN LA Contraportada Table of Contents Important Safety warnings & instructionsGeneral safety warnings and instructions for all tools Important safety instructions For battery chargers LSWV36 Power HeadDo not attempt to charge the battery pack with any chargers ComponentsImportant safety instructions For battery Packs Recommended Minimum Wire Size for Extension CordsCharging Procedure Charger DiagnosticsBad battery Hot/Cold pack delayInstalling and Removing the Battery Pack Fan Cover assembly To attach Sweeper Mode assemblyTube assembly Parts. this Sweeper is for OperationSweeper operation VacUUM operation What to do if the unit jams Figure MWith a small wooden stick. Do not use a metal implement or Actions that may lead to the unit jamming areMaintenance AccessoriesHow to avoid jamming the unit Cleaning and StorageTRoubleshooting Problem SolutionService Information Full Three-Year Home Use WarrantyNuméro de catalogue LSWV36 Table DES Matières DéfinitionsDirectives ET Avertissements DE Sécurité Importants Graves blessuresUniquement des pièces de rechange Black & Decker Générales Pour Tous LES OutilsLire et respecter toutes les mesures de sécurité Composantes Avertissement risque de choc électriqueProtéger le chargeur de la pluie et de la neige Calibre de fil minimum recommandé pour les rallongesTenir le cordon éloigné des surfaces chauffées Directives de sÉcuritÉ importantes pour Les blocs-piles NE Jamais tenter de relier deux chargeurs ensembleRecommandations en matière de rangement Fonctions de diagnostic du chargeurProcédure de charge Pile en mauvais étatIndicateur de L’état De charge figure B Pile laissée dans le chargeurRemarques importantes pour le chargement Indicateur DE L’ÉTAT DE Charge Figure BAssemblage DU Mode Balayeuse Insertion et retrait du bloc-pilesInsertion DU BLOC-PILES SAC Collecteur Figure DInterrupteur FonctionnementFonctionnement DE LA Balayeuse Le sac avant de réutiliser l’appareilAccessoires EntretienActions Pouvant Entraîner LE Blocage DE L’APPAREIL Comment Éviter LE Blocage DE L’APPAREILDEpannage Page Modelo N LSWV36 Índice Pautas DE SEGURIDAD/DEFINICIONESAdvertencias E Instrucciones Importantes DE SeguridadTenga Mucho Cuidado cuando limpie en escalones 30 Guárdese bajo techoComponentes No exponga el cargador a la lluvia ni a la nieve Conserve Estas InstruccionesRecomendaciones con respecto al almacenamiento Procedimiento de carga Batería en mal estadoRetraso por paquete caliente/frío Dejar la batería en el cargadorIndicaDOr deL Estado de la carga figure B Instalación y extracción del paquete deEnsamblaje EN Modo DE Barredora La carga. Éste no indica la capacidad deEnsamblaje EN Modo DE Aspiradora OperaciónBolsa DE Recolección Figura D Ensamblaje DEL Tubo Aspirador Figuras E, F Y GAnteojos de seguridad. Use una Ropa holgada lejos de las aberturas y lasPiezas en movimiento. Esta Barredora Nota Asegúrese de que la barredoraLimpieza Y Almacenamiento MantenimientoCómo Evitar LA Obstrucción DE LA Unidad Detección de problemas AccesoriosInformación de mantenimiento El sello RbrcGarantía completa de tres años para Uso en el hogar Solamente para Propósitos de MéxicoPage Page Page Solamente Para Propositos DE Mexico

LSWV36, LSWV36R specifications

The Black & Decker LSWV36 and LSWV36R are versatile cordless leaf blowers that embody efficiency and convenience for outdoor maintenance. These models provide exceptional power in a lightweight design, making them ideal for homeowners looking to keep their yards tidy without the hassle of cords or gas.

One of the standout features of the LSWV36 and LSWV36R is the 36-volt lithium-ion battery. This technology ensures longer run times and faster charging, allowing users to complete their tasks without frequent interruptions. The battery delivers consistent power, ensuring that the blower operates at peak performance until the charge is exhausted. Users can expect up to 30 minutes of runtime on a single charge, which is generally sufficient for most residential lawns.

Both models boast a powerful wind speed of up to 120 mph, allowing for efficient leaf removal and debris clearance from sidewalks, driveways, and patios. The lightweight and ergonomic design of the blowers makes them easy to maneuver, reducing arm fatigue during extended use. Weighing approximately 7.5 pounds, these leaf blowers are manageable for users of all ages.

The LSWV36 and LSWV36R come equipped with two speed settings, providing the flexibility to tackle different tasks. The lower speed setting is perfect for clearing grass clippings, while the higher speed is ideal for moving stubborn leaves and heavier debris. This feature ensures that users have control over the tool's performance, adapting to the specific needs of their outdoor spaces.

Moreover, the LSWV36R model features a vacuum and mulching system, which adds to its versatility. Users can easily switch from blowing leaves to vacuuming them up, transforming yard waste into mulch for composting or garden use. This dual functionality not only saves time but also assists in creating an eco-friendly gardening solution.

In summary, the Black & Decker LSWV36 and LSWV36R deliver powerful performance, runtime efficiency, and dual functionality, making them indispensable tools for maintaining a clean and orderly yard. They combine innovative technology with user-friendly features, providing an excellent solution for anyone seeking a reliable cordless leaf blower. Whether blowing leaves or mulching yard waste, these models are sure to exceed expectations.
Top Page Image Contents