Blount manual 633GC OPERATOR’S Manual, Safety

Page 5

633GC OPERATOR’S MANUAL

SAFETY

THE FOLLOWING SYMBOL APPLIES TO ALL THE ITEMS LISTED ON THIS PAGE

WARNING

A potentially hazardous situation exists which, if not avoided, could result in death or serious injury.

Chain breakage can result in high-speed ejection of parts, which can result in death or serious personal injury to operators or bystanders. The items listed below are critical to minimizing the risk of chain breakage and injury.

•DO NOT operate a diamond chainsaw with a damaged, modified, broken, or missing side cover, bottom guard, or guard flap. The side cover, bottom guard, and guard flap provides protection against contact with moving parts, ejected debris, broken diamond chain, thrown water and concrete slurry.

•DO NOT operate a saw with loose, missing, damaged or improperly repaired parts.

•DO NOT install or run the chain backwards. The bumper must lead the segment into the cut.

•DO NOT insert a diamond chainsaw into a slot narrower than the chain segments. Rapid pushback might occur. Reference: Most diamond segments are .225 inches (5.72 mm) wide.

•DO NOT use damaged, modified or improperly repaired chain.

•DO NOT run a diamond chainsaw upside-down. Concrete debris can fly back into the operator’s face.

•DO NOT cut ductile iron pipe with a diamond chainsaw. Segment loss or chain breakage may occur.

P/N 70944 Jan 07

© 2007 ICS, Blount Inc.



Page 4 Page 6
Image 5
Page 4 Page 6
Contents 633GC Page 633GC OPERATOR’S Manualtable of Contents Symbols & Labels 633GC OPERATOR’S Manual 633GC OPERATOR’S Manual SafetyFollowing Symbol Applies to ALL the Items Listed on this General Safety Precautions Safety 633GC OPERATOR’S ManualFollowing Symbol Applies to ALL Items Listed on this Engine BREAK-IN Technical Specifications 633GC OPERATOR’S Manual SET-UP Guide BAR and Diamond Chain InstallationSET-UP 633GC OPERATOR’S Manual SET-UP Fuel Handling Operation 633GC OPERATOR’S ManualFuel Mixing FuelingStarting and Stopping a Diamond Chainsaw OperationPlanning the CUT PRE-CUT ChecklistCutting Tips Cutting with the 633GCSystem CLEAN-UP After Each USE MaintenanceAfter 10 Hours of USE After 40 Hours of USEAIR Filter Maintenance 633GC OPERATOR’S ManualStarter Housing Assembly Tensioning the Recoil Spring Starter Rope ReplacementChain Tensioner Drive Sprocket Removal Drive SprocketSpark Plug Drive Sprocket InstallationGuide Bars CarburetorMaintenance 633GC OPERATOR’S Manual Further questions? Call 1-800-321-1240 or 633GCTROUBLESHOOTINGPERATOR’S Manual TroubleshootingINCH-FOOT Definition 633GC OPERATOR’SREFERENCEMANUAL Approximate Cutting RatesPage 633GC OPERATOR’S Manual
Top Page Image Contents