Blount 633GC manual Set-Up, Guide BAR and Diamond Chain Installation

Page 9

633GC OPERATOR’S MANUAL

SET-UP

GUIDE BAR AND DIAMOND CHAIN INSTALLATION

STEP 1

Loosen side cover nuts and remove side cover.

STEP 2

Place bar onto studs and chain adjustment pin.

STEP 3

Mount the diamond chain on the guide bar starting at the drive sprocket and continue over the guide bar nose.

Install the diamond chain correctly. If using a single bumper chain, the bumper must always lead the segment into the cut as shown here.

STEP 4

Install the side cover.

P/N 70944 Jan 07

© 2007 ICS, Blount Inc.

Image 9

Contents 633GC Page 633GC OPERATOR’S Manualtable of Contents Symbols & Labels 633GC OPERATOR’S Manual Safety Following Symbol Applies to ALL the Items Listed on this633GC OPERATOR’S Manual Safety 633GC OPERATOR’S Manual Following Symbol Applies to ALL Items Listed on this General Safety Precautions Engine BREAK-IN Technical Specifications 633GC OPERATOR’S Manual SET-UP Guide BAR and Diamond Chain InstallationSET-UP 633GC OPERATOR’S Manual SET-UP Fuel Handling Operation 633GC OPERATOR’S ManualFuel Mixing FuelingStarting and Stopping a Diamond Chainsaw OperationPlanning the CUT PRE-CUT ChecklistCutting Tips Cutting with the 633GCSystem CLEAN-UP After Each USE MaintenanceAfter 10 Hours of USE After 40 Hours of USEMaintenance 633GC OPERATOR’S Manual Starter Housing AssemblyAIR Filter Tensioning the Recoil Spring Starter Rope ReplacementChain Tensioner Drive Sprocket Removal Drive SprocketSpark Plug Drive Sprocket InstallationGuide Bars CarburetorMaintenance 633GC OPERATOR’S Manual Further questions? Call 1-800-321-1240 or 633GCTROUBLESHOOTINGPERATOR’S Manual TroubleshootingINCH-FOOT Definition 633GC OPERATOR’SREFERENCEMANUAL Approximate Cutting RatesPage 633GC OPERATOR’S Manual