Best WC26E manual Halogen Bulbs, Fuse Replacement, Eration on the appliance

HALOGEN BULBS

This range hood requires two halogen bulbs (Type T3, 12Volt, 20Watt Max, G-4 Base).

WARNING: Always switch off the elec- trical supply before carrying out any op-

eration on the appliance.

To change bulbs:

1.Open the cover by prying from the proper slots. Fig. 2.

2.Remove the bulb by pulling sideways. (DO

NOT ROTATE).

! CAUTION: Bulb may be hot.

3.Replace with Type T3, 12Volt, 20 Watt Max, G-4 Base halogen bulb. Do not touch replacement bulb with bare hands!

! CAUTION: Use of bulbs greater than 20 watts will cause the fuse to open.

FUSE REPLACEMENT

IF LIGHTS FAIL TO OPERATE, DISCON- NECT POWER AT THE SERVICE EN- TRANCE. CHECK THE FUSE AND RE- PLACE IF NECESSARY.

1.Remove the grease filter.

2.Unscrew the cap from the fuse holder and remove the fuse.

3.Replace the fuse with the same size and amperage (5 x 20mm, 4 amp, 125 volt).

! CAUTION: Use a fuse greater than 4 amps may damage the transformer.

4.Reinstall the fuse holder cap.

5.Reconnect power at the service entrance.

FIG. 2

FUSE

GREASE FILTER

FIG. 3

- 5 -