Exmark 000 & higher, 312 manual Operation, Weekly, Tank Requalification

Page 8

Safety

Inspect the LPG tank and the fuel connection joint for leaks. Use the following procedure below to detect leaks:

Apply an approved leak detector solution, obtained from a trained and qualified LPG distributor, or a thick non-ammonia soapy water solution (50% non-ammonia soap and 50% water). (A leak detector solution that contains ammonia will cause the fittings to corrode and leak.)

Using a small brush or spray bottle, apply the solution around all the fittings of the LPG tank and the fuel connection joint.

Slowly open the gas valve a half-turn.

If bubbles are detected, the joint or fitting has a leak. Shut off the valve, tighten the leaking connection, and slowly open the valve again. If bubbles still appear, Do Not use the tank. If it is safe to do so, remove the tank from your mower; otherwise, contact trained and qualified personnel immediately.

If no bubbles are detected, the LPG tank may be used.

Weekly:

Check the entire LPG fuel delivery system for damage or deterioration.

Check the entire LPG fuel delivery system for leaks at all joints using the same method as described in the previous section.

Follow all the inspection checks as specified in the two previous inspection sections.

Tank Requalification:

USDOT (United States Department of Transportation) regulations require LPG tanks to be inspected, requalified, and marked within 12 years of the manufacture date and on a regular basis thereafter. Typically this occurs when the tank is refilled; contact a trained and qualified LPG tank provider for more details.

Do Not fill the LPG tank if it is beyond the requalification period.

Do Not fill damaged or rusted LPG tanks.

Operation

WARNING

Operating engine parts, especially the muffler, become extremely hot. Severe burns can occur on contact and debris, such as leaves, grass, brush, etc. can catch fire.

Allow engine parts, especially the muffler, to cool before touching.

Remove accumulated debris from muffler and engine area.

Install and maintain in working order a spark arrester before using equipment on forest-covered, grass-covered, or brush-covered unimproved land.

WARNING

Engine exhaust contains carbon monoxide, which is an odorless deadly poison that can kill you.

Do Not run engine indoors or in a small confined area where dangerous carbon monoxide fumes can collect.

Operate only in daylight or good artificial light, keeping away from holes and hidden hazards.

Be sure all drives are in neutral and parking brake is engaged before starting engine.

Never raise deck with blades running.

Never operate the mower with damaged guards, shields, or covers. Always have safety shields, guards, switches and other devices in place and in proper working condition.

Never mow with the discharge deflector raised, removed or altered unless there is a grass collection system or mulch kit in place and working properly.

Do Not change the engine governor setting or overspeed the engine.

Park machine on level ground. Stop engine, wait for all moving parts to stop, remove key and engage parking brake:

Before checking, cleaning or working on the mower.

After striking a foreign object or abnormal vibration occurs (inspect the mower for

8

Image 8
Contents Turf Tracer Series LP All Rights Reserved Introduction Contents Safety Safety Alert SymbolSafe Operating Practices TrainingSafety Inspection With each tank changeTank Requalification OperationWeekly Maintenance and Storage Slope OperationSafety Safety Safety and Instructional Decals 553049 98-5954 103-1798 103-1976 103-2076 103-2103 103-2242 103-2243 103-4935 109-3148 109-9870 109-9875 116-0404 117-2718 109-9906 Systems SpecificationsModel Numbers Dimensions Product Overview Torque RequirementsOperation ControlsPre-Start Operating Instructions Open the Fuel ValveStarting the Engine Disengaging the PTODriving Forward Driving the MachineDrive Lever/Neutral Lock Latch Operation Adjusting the Cutting Height Driving in ReverseTransporting a Unit Adjusting the Anti-Scalp RollersTransporting Operation Maintenance Recommended Maintenance SchedulesCheck Battery Charge Recommended Jump Starting ProcedureCheck Engine Oil Level Proposition 65 WarningDo Not jump start a weak battery if these conditions exist Check Mower BladesReplacing the Discharge Deflector Check for Loose Hardware Check Safety Interlock SystemService Pre-Cleaner Element and Air Cleaner Change Engine Oil Check Hydraulic Oil LevelCheck Tire Pressures Check Condition Of BeltsCheck LPG Tank Check LPG Fuel Delivery SystemCheck Spark Plugs Change LPG TankChange Hydraulic System Filter LevelHydraulic System Air Purge Wheel Hub-Slotted Nut Torque Specification Inspect PTO Clutching Belt TensionThread Locking Adhesives Mobil HTS Grease Or Food-Grade Anti-seizePark Brake Adjustment Hydro Drive Linkage AdjustmentDielectric Grease Deck LevelingAdjust Neutral Control Linkages Adjust Hydro Control LinkagesDrive Lever Linkage Adjustment Need to be adjustedTracking Adjustment Hydro Pump Spring Tension SettingPTO Safety Switch LPG RegulatorClean Engine and Exhaust System Area Remove Engine Shrouds and Clean Cooling FinsClean Debris From Machine Clean Grass Build-Up Under DeckMaintenance Troubleshooting Problem Possible Cause Corrective ActionSee Check Spark Plug section Troubleshooting Schematics Electrical DiagramHydraulic Diagram Exmark Commercial Turf Equipment Page Service Record Date Description of Work Done Service Done ByPage This page may be copied for personal use See EXMARK’S Complete Line of Accessories and Options
Related manuals
Manual 60 pages 29.4 Kb Manual 48 pages 5.05 Kb Manual 52 pages 61.7 Kb Manual 60 pages 62.85 Kb Manual 60 pages 57.72 Kb Manual 60 pages 43.2 Kb Manual 64 pages 1.01 Kb Manual 56 pages 15.39 Kb Manual 28 pages 32.2 Kb Manual 52 pages 57.34 Kb Manual 60 pages 42.39 Kb Manual 60 pages 23.73 Kb Manual 40 pages 46.04 Kb

0, 312, 000 & higher specifications

Exmark has long been synonymous with excellence in the world of lawn care and landscaping, and their 000 & higher, 0,312 series is no exception. Engineered for both professional landscapers and passionate homeowners, this series brings together innovative technology with robust design to deliver unparalleled performance and durability.

One standout feature of this series is its powerful engine options, which ensure efficient cutting and grass handling capabilities. The engines are designed to provide consistent power and reliability, even in tough conditions. This reliability is complemented by high-quality cutting decks that deliver precision cuts and exceptional mulching abilities, ensuring that your lawn stays healthy and vibrant.

The cutting height adjustment system allows users to easily modify the height to suit various types of grass and landscaping needs. This adaptability ensures that your grass is always maintained at the optimal length for health and aesthetics. The ergonomic design of the handles incorporates comfort grips, reducing fatigue during prolonged use while providing excellent control over the machine.

Another significant aspect of the 000 & higher, 0,312 series is its advanced technology integration. Many models in this series come equipped with efficient fuel systems that enhance performance while minimizing fuel consumption. Furthermore, the inclusion of intelligent controls and monitoring systems enables users to make informed adjustments, ensuring that the equipment operates at peak performance.

The robust construction of the chassis and frame means that these machines can withstand the rigors of everyday use in various landscapes. The high-quality materials used in the manufacturing process enhance the longevity of the equipment, making it a worthy investment for those serious about maintaining their lawns.

In addition, Exmark places a strong emphasis on safety features. The series includes protective shields and easy-to-access controls that prioritize user safety without compromising on functionality. Maintenance is made simple through user-friendly designs, allowing for quick access to essential components.

In conclusion, the Exmark 000 & higher, 0,312 series presents a perfect blend of power, innovation, and user-focused features. With its reliable performance, flexible adjustment options, and sturdy design, this series continues to set the standard for excellence in lawn care equipment. Whether you’re a professional or a homeowner, the Exmark 000 & higher, 0,312 series stands ready to meet all your landscaping needs.