Hayter Mowers SST38/ST42 Seat Position, Headlights, Cutterblade Control, Height of CUT Setting

Page 20

1.20

SEAT POSITION

OPERATING THE TRACTOR

1.20

The seat can be adjusted forward or backwards. Raise the seat (1), loosen the adjuster knobs (2), adjust the seat to the desired position and re-tighten the adjuster knobs. Lower the seat.

IMPORTANT - Ensure that the adjuster knobs are fully tightened before operation.

2

2

1

1. Seat

2. Adjuster Knobs

HEADLIGHTS

The lights are an integral function of the ignition switch. Turn the ignition key to the symbol to switch them on.

CUTTERBLADE CONTROL

The cutterdeck drive switch engages and disengages drive to the cutterblades.

- Engage Drive: Pull the cutterdeck drive switch out.

- Disengage Drive - Push the cutterdeck drive switch in.

HEIGHT OF CUT SETTING

The height of cut lever is used to raise and lower the cutterdeck to the desired height of cut.

Move the height of cut lever inwards to disengage it from the height of cut notches, then push forwards to lower or pull backwards to raise the height of cut. Release the lever into the required position and ensure that it locks securely into the appropriate notch. There are six height of cut positions. These are indicated by the numbered notches, 1 to 6.

IMPORTANT: Always select the height of cut to suit operating con- ditions. Prevent engine overloading and blockages by avoiding low cuts in long grass conditions. Be prepared to make two cuts when the grass is long.

150005MA010302A

Image 20

Contents ST38/ST42 Page Be Alert CONTENTS1.4 CONTENTS1.5 Preparation Safety PrecautionsTraining Operation Safety Precautions Maintenance and Storage Health and Safety at Work ActDecals Decal Caution Hands and Feet Part NoDecal General Warning Part No MU44x6815 Decal Drawbar Warning Part No MU44x6138Decal Height of Cut Part No MU44x6279 Decal Transaxle Bypass Lever Part NoDecal Level Position Part No MU44x6456 Guard Rear Flap Part No Decal Powered Sweeper Collector Part NoDecal Serial Number EC Conformity Information EC Declaration of ConformityEC Declaration of Conformity Vibration InformationEC Declaration of Incorporation EC Declaration of IncorporationIntroduction IntroductionEngine SpecificationsDetail Specifications Recommended Lubricants Weights and DimensionsWeight Operator Controls Safety NoticeOperating the Tractor Before Starting the Engine Parking BrakeHeight of CUT Setting Seat PositionHeadlights Cutterblade ControlCutterdeck Level Setting To level the cutterdeckThrottle Control Choke ControlTravel Ignition KEYTransaxle Bypass Lever Fuel Filler CAPEngine OIL Filler CAP Operator Safety System Starting and Stopping the EngineEmptying the Sweeper Collector Sweeper Drive SwitchSweeper Working Height Setting Attaching the sweeper collector Sweeper Collector Lift LeverATTACHING/DETACHING the Sweeper Collector Detaching the sweeper collector Maintenance MaintenanceEngine Age which will not be covered by the warranty Engine OILOIL Filter Do not overfillFuel and Carburation Filling the fuel tankFuel Filter Combustion and Cooling AirElectrical BatterySpark Plug Removing a rear wheel Tyres and WheelsRemoving a front wheel Lubrication Replacing the Secondary Drive Belt CutterdeckReplacing Primary Drive Belt Cutterdeck Attachment MAINTENANCE1.36Cutterdeck Removal Powered Sweeper Collector Replacement of the Primary Drive BeltReplacement of the Brush Drive Belt Replacement of the Bristle SectionsGrass Cutting Faults Grass Cutting FaultsTrouble Shooting Trouble ShootingTrouble Shooting Trouble Shooting Electrical Circuit Diagram Description Parts No