Hayter Mowers SST38/ST42 specifications MAINTENANCE1.36, Cutterdeck Removal, Cutterdeck Attachment

Page 36

1.36

CUTTERDECK

MAINTENANCE1.36

Continued.

Cutterdeck Removal:

- Refer to the ‘Cutterdeck Lever Setting’ procedure and move the height of cut lever to the deck levelling position.

- Remove the R-clips and washers from the rear suspension brackets.

- Remove the R-clips and washers from the rear lift links.

- Disconnect the extension spring from the chassis.

- Remove the R-clip from the hanger rod. Push the hanger rod through and then withdraw from between the hanger brackets. Allow the front suspen- sion bracket to hinge forward and lay on the ground.

- Remove the primary drive belt from the elective clutch output pulley.

- Pull the cutterdeck assembly away from beneath the tractor.

Cutterdeck Attachment:

-Follow the cutterdeck removal procedure in reverse order to install the cutterdeck.

-Ensure that the primary drive belt is correctly routed and located.

-Follow the ‘Cutterdeck Level Setting’ procedure to ensure correct set-up and operation.

150005MA010302A

Image 36

Contents ST38/ST42 Page Be Alert CONTENTS1.4 CONTENTS1.5 Safety Precautions TrainingPreparation Operation Safety Precautions Maintenance and Storage Health and Safety at Work ActDecals Decal Caution Hands and Feet Part NoDecal General Warning Part No MU44x6815 Decal Drawbar Warning Part No MU44x6138Decal Transaxle Bypass Lever Part No Decal Level Position Part No MU44x6456Decal Height of Cut Part No MU44x6279 Decal Powered Sweeper Collector Part No Decal Serial NumberGuard Rear Flap Part No EC Conformity Information EC Declaration of ConformityEC Declaration of Conformity Vibration InformationEC Declaration of Incorporation EC Declaration of IncorporationIntroduction IntroductionSpecifications Detail SpecificationsEngine Weights and Dimensions WeightRecommended Lubricants Safety Notice Operating the TractorOperator Controls Before Starting the Engine Parking BrakeHeight of CUT Setting Seat PositionHeadlights Cutterblade ControlCutterdeck Level Setting To level the cutterdeckThrottle Control Choke ControlTravel Ignition KEYFuel Filler CAP Engine OIL Filler CAPTransaxle Bypass Lever Operator Safety System Starting and Stopping the EngineSweeper Drive Switch Sweeper Working Height SettingEmptying the Sweeper Collector Sweeper Collector Lift Lever ATTACHING/DETACHING the Sweeper CollectorAttaching the sweeper collector Detaching the sweeper collector Maintenance MaintenanceEngine Age which will not be covered by the warranty Engine OILOIL Filter Do not overfillFuel and Carburation Filling the fuel tankFuel Filter Combustion and Cooling AirBattery Spark PlugElectrical Tyres and Wheels Removing a front wheelRemoving a rear wheel Lubrication Cutterdeck Replacing Primary Drive BeltReplacing the Secondary Drive Belt MAINTENANCE1.36 Cutterdeck RemovalCutterdeck Attachment Powered Sweeper Collector Replacement of the Primary Drive BeltReplacement of the Brush Drive Belt Replacement of the Bristle SectionsGrass Cutting Faults Grass Cutting FaultsTrouble Shooting Trouble ShootingTrouble Shooting Trouble Shooting Electrical Circuit Diagram Description Parts No