Husqvarna RZ54i / 967003604 warranty Service Minder, Tracking Knob, Seat Adjustment Lever

Page 22

CONTROLS

Service Minder

The service minder displays the total number of hours the engine has run and indicates when the engine and mower need servicing.

After every 50 hours of operation, an oil can icon will appear and stay on for two hours, before an automatic reset occurs. To service the engine and mower, see the Service Journal of this manual.

Note: The service minder operates (clocks hours) only when the engine is running or when the SmartSwitch is active (unlocked).

Tracking Knob

If the mower is not tracking straight, check the air pressure in both rear tires. Recommended air pressure is 15 psi (103 kPa / 1 bar) for all tires. Tracking must be checked on a flat and level concrete or blacktop surface.

Rotating the tracking knob allows fine tuning adjustments so the machine tracks straight with the steering control levers in the full forward position.

Rotate the knob counter clockwise (as viewed from the operation position) to increase the speed on the left lever. Rotate clockwise to decrease speed.

Seat Adjustment Lever

The seat can be adjusted lengthways. When making adjustments, the lever under the right side of the seat is pulled up, after which the seat can be moved backward or forward.

IMPORTANT INFORMATION

Seat should not be adjusted while unit is in motion.

8058-247

Service minder

8058-187

Tracking knob

8058-252

Lengthways adjustment

22

Image 22 Contents
Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxShut off engine before Performing any Safety Instructions SafetyGeneral Operation Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Risk of sparking Safety System Transport Spark Arrestor Controls Control LocationsSteering Control Levers Throttle Control Park BrakeCold Weather Control Ignition Switch Blade SwitchSmartSwitch Courtesy Buttons Seat should not be adjusted while unit is in motion Service MinderSeat Adjustment Lever Tracking KnobFuse Fuel TankBypass Linkages Cutting Height AdjusterFuel Shut Off Valve Always raise the deck to the highest position for transportTraining OperationSteering SmartSwitch Ignition Resetting ignition system passcodeBefore Starting Starting the Engine Place controls in neutral position Full throttle position Important Information Ignition System Faults Running Stopping the Engine Operating On Hills Mowing Tips Jumper Cables Use Weak BatteryHeadlights To remove cablesChecking Battery Charge System Battery Voltage LightMoving Machine By Hand Maintenance Maintenance ScheduleBefore After Year Battery Replacing batterySteering controls locked in neutral Anti-scalp Rollers Removal and installation of caster wheelTire Pressures Caster WheelsBelts Deck Belt InstallationDeck Belt Removal Cutting Blades Adjusting the Mower Deck Leveling deckUse protective glasses when cleaning and washing CleaningHardware Lubrication Schedule LubricationGeneral Deck Spindles Wheel and Deck ZerksTransmission Front Wheel MountTroubleshooting Problem CauseTroubleshooting Storage ServiceWinter Storage Schematic Engine Technical DataDimensions TransmissionStandard Hardware Torque SpecificationsAccessories Metric Standard HardwareConformity Certificates USA requirementsService Journal Delivery ServiceHour Service After the First 10 HoursAt Least Once Each Year Page 115 650227 Rev a 2013-10-15