Husqvarna RZ54i / 967003604 warranty Operating On Hills

Page 34

OPERATION

Operating On Hills

Read the safety instructions Driving on Slopes in the

Safety section.

WARNING!

Do not drive up or down hills with slopes greater than 10 degrees. Do not drive across slopes.

• The slowest speed possible should be used before starting up or down hills.

• Avoid stopping or changing speed on hills.

• If stopping is absolutely necessary, pull steering
controls into the neutral position and push to the	8058-190
outside of the unit. Engage the park brake.	Place controls in neutral position

•To restart movement, release the park brake.

•Pull the control levers back to the center of the mower and press forward to regain forward motion.

•Make all turns slowly.

8058-187

Park brake released

34

Image 34

Contents

Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxShut off engine before Performing any Safety Instructions SafetyGeneral Operation Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Risk of sparking Safety System Transport Spark ArrestorControls Control LocationsSteering Control Levers Throttle Control Park BrakeCold Weather Control Ignition Switch Blade SwitchSmartSwitch Courtesy Buttons Seat should not be adjusted while unit is in motion Service MinderSeat Adjustment Lever Tracking KnobFuse Fuel TankBypass Linkages Cutting Height AdjusterFuel Shut Off Valve Always raise the deck to the highest position for transportTraining OperationSteering SmartSwitch Ignition Resetting ignition system passcodeBefore Starting Starting the Engine Place controls in neutral position Full throttle position Important Information Ignition System Faults Running Stopping the Engine Operating On Hills Mowing Tips Jumper Cables Use Weak BatteryHeadlights To remove cablesChecking Battery Charge System Battery Voltage LightMoving Machine By Hand Maintenance Maintenance ScheduleBefore After Year Battery Replacing batterySteering controls locked in neutral Anti-scalp Rollers Removal and installation of caster wheelTire Pressures Caster WheelsBelts Deck Belt InstallationDeck Belt Removal Cutting Blades Adjusting the Mower Deck Leveling deckUse protective glasses when cleaning and washing CleaningHardware Lubrication Schedule LubricationGeneral Deck Spindles Wheel and Deck ZerksTransmission Front Wheel MountTroubleshooting Problem CauseTroubleshooting Storage ServiceWinter Storage Schematic Engine Technical DataDimensions TransmissionStandard Hardware Torque SpecificationsAccessories Metric Standard HardwareConformity Certificates USA requirementsService Journal Delivery ServiceHour Service After the First 10 HoursAt Least Once Each Year Page 115 650227 Rev a 2013-10-15