![](/images/new-backgrounds/1112943/11294359x1.webp)
OPERATION
7.Press and release the S/S button to activate the ignition switch. Check that the indicator is blinking blue.
IMPORTANT INFORMATION
Either of two actions will wake up the ignition
Enter the passcode and press the S/S button. The S/S button will flash one slow green blink if the code is accepted and will change to a rapid green blink.
If the S/S button has accepted the code but does not stay lit with a rapid green blink, see Ignition System Faults on the following page.
8.When the S/S button displays a rapid green blink, press and release the button once more to start the engine.
Allow the engine to run at a moderate speed, approximately mid throttle, for a short time before use.
IMPORTANT INFORMATION
Under normal starting conditions, use a press and release method for the ignition start/stop switch. Do not press and hold.
NOTE: For the first start after the unit has sat idle for an extended period of time, or has been refueled after being run out of gas, the engine may require an extended start attempt to reprime the fuel system. Press and hold down the S/S switch for three seconds and then release. This will prompt the engine starter to attempt starting the engine for up to ten seconds (instead of the normal five seconds), allowing time for fuel to be pulled into the engine.
Press the S/S button and enter the passcode
Press S/S button to start
WARNING!
Engine exhaust and certain vehicle components contain or emit chemicals considered to cause cancer, birth defects or other reproductive system damage. The engine exhaust contains carbon monoxide, which is a odorless, colorless, poisonous gas. Do not use the machine in enclosed spaces.
30