14-18
Cisco Systems IntelligentGigabit Ethernet Switch Modules for the IBMBladeCenter, Software Configuration Guide
24R9746
Chapter14 Configuring IGMP Snooping and MVR
Configuring MVR
Default MVR ConfigurationTable14-5 shows the default MVR configuration.
MVR Configuration Guidelines and LimitationsFollow these guidelines when configuring MVR:
•Receiver ports cannot be trunk ports. Receiver ports on a switch can be in d ifferent VLANs, but
should not belong to the multicast VLAN.
•The maximum number of multicast entries that can be configured on a switch (that is, the maximum
number of television channels that can be received) is 256.
•Each channel is one multicast stream destined for a unique IP multicast address. Th ese IP addresses
cannot alias between themselves or with the reserved IP multicast addresses (in the
range 224.0.0.xxx).
•MVR does not support IGMPv3 messages.
Note For complete syntax and usage information for the commands used in this section, see the command
reference for this release.
Configuring MVR Global ParametersYou do not need to set the optional MVR parameters if you choose to use the default settings. If you do
want to change the default parameters (except for the MVR VLAN), you must first enable MVR.
Beginning in privileged EXEC mode, follow these steps to configure MVR parameters:
Table14-5 Default MVR Configuration
Feature Default Setting
MVR Disabled globally and per interface
Multicast addresses None configured
Query response time 0.5 second
Multicast VLAN VLAN 1
Mode Compatible
Interface (per port) default Neither a receiver nor a source port
Immediate Leave Disabled on all ports
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 mvr Enable MVR on the switch.