Samsung HMX-Q200BP Connecting to a WLAN and configuring network settings, Configuring the network settings

Connecting to a WLAN and configuring network settings

Configuring the network settings			5 Touch the	tab.
You can configure network settings manually. Note that configuring			• The camcorder connects to the network via the selected AP.
these settings manually is not necessary in most cases. If your			• Even if AP authentication and Data Encryption have been detected,
camcorder connected to the network after you followed the directions
			set the authentication mode to Open or Shared.
on page 72, your camcorder has adjusted these settings and you do
			• If the camcorder does not detect the AP automatically, you can set
not need to configure them manually.
			the network properties directly. ￿page 74
1 Press the [Home ( )] button ￿ touch Social Sharing.			• Data encryption settings by authentication type are below:
			- Open ￿ Disabled or WEP
2 Touch the Wi-Fi setting (			- Shared ￿ WEP
		) tab.	- WPA-PSK ￿ TKIP, AES, or TKIP/AES Mixed
• The camcorder automatically searches for available AP devices.			• When the Data Encryption function is set to WEP or TKIP for
3 Touch the			802.11n AP connection, you can access in the 802.11g mode.
	tab next to an AP.		In the 802.11g mode, the network connection and speed are not
			guaranteed.

Wi-Fi Setting

Samsung 1

Samsung 2

Samsung 3

Samsung 4

4Touch each submenu and enter the required information.

ItemDescription

Select an authentication type according to your AP’s setting.

Authentication When you select Open or Shared, WPA is automatically set.

Data Encryption Select an encryption type according to your AP’s setting.

Network

Enter the password using the virtual keyboard. ￿page 75

Password

IP Setting

The default is Auto. You can select Manual to set the IP address manually.

Wireless network (HMX-QF20 only) 73