Using Auto Backup to send videos or photos
Installing the programme for Auto backup on your PC
1Connect the camcorder to a PC with the USB cable.
2Turn on the camcorder.
•The computer recognises the camcorder and
3When the
•To install the programme, follow the instructions on the
•After installation, reconnect the camcorder and then confirm the server information message.
•To run the programme, disconnect the camcorder from the PC.
This programme is for backing up files to the PC based on Windows OS.
Sending photos or videos to a PC
1Press the [Home (
Social Sharing Auto Backup | TV Link |
Settings
•2
2 Touch the Confirm tab.
•The camcorder will automatically attempt to connect to a WLAN via the most recently connected AP device.
•If the camcorder has not previously been connected to a WLAN, it will search for available AP devices. page 72
•If your PC has turned on, the PC recognises the camcorder and
•If your PC supports the Wake on LAN (WOL) feature, you can
turn on the PC automatically by searching for the PC from your camcorder. pages 79~80
3The camcorder will prepare to send the files and send them to the PC.
•You cannot select individual files to send. This function is available only for newly stored files on the camcorder.
•The progress will be shown on the PC monitor.
• The camcorder will search for available access points even if you are connecting to the same access point again.
•If you turn off the camcorder or remove the battery while sending files, the file transfer will be interrupted.
•While you are using this feature, the buttons on the camcorder will be disabled.
•You can connect only one camcorder to the PC at a time for sending files.
•The backup may be canceled due to network conditions.
•Videos or photos can be sent to a PC one time only.
•Files cannot be sent again even if you reconnect your camcorder.
Wireless network