Available after switching to Monitor mode by pressing the [MONITOR] button on the remote control.
AUTO
Selects the screen status automatically.
P.MODE
Selects the screen mode.
POWER
Turns the monitor power on/off.
NUMBER [0~9]
Changes the system ID.
+/-
Adjusts the audio volume.
MENU
Displays the Setup Menu.
Up/Down/Left/Right(▲▼◄ ►)/ENTER
Moves the cursor up/down/left/right, and runs the
Select Menu.
FREEZE
Screen Freeze.
UNDER SCAN
Displays the video screen within a screen.
ID RESET
Initializes the ID value to 01.
MONITOR
Activates the monitor function.
ID
Sets the ID.
Select 2 digits from 0 ~ 9 while pressing the ID Key.
MUTE
Mutes the audio out.
SOURCE
Selects the input signal source.
PIP
Selects or deselects the PIP function.
OVERVIEW
CHANNEL | Press any button among 1 to 9. |
|
|
1.Press the ID button of the remote control and check the ID displayed on the DVR screen. The factory default ID of the remote control is 00.
2.Enter 2 digits of your selection in order, while pressing the system [ID] button.
3.When ID input is done, press the system [ID] button again to check the setting.
M If you want to change the remote control ID to 08: Press 0 and 8 in order while the system [ID] button is pressed. Remote control's ID and DVR’s ID should be matched for proper operation. Refer to “Remote Devices”. (Page 46)