Compex Systems 802.11N manual

Contents

Main Copyright 2009 Compex Systems Pte Ltd Trademark Information Disclaimer Page Page Table of Contents Page Overview the Product Introduction Features and Benefits Operation Modes and Connection Examples Access Point and Access Point WDS Mode Access Point WDS Mode Station Mode Station WDS Mode Router Mode Repeater WDS Mode Device Panel Views and Descriptions Install the Hardware Antenna Alignment Installation Direction Setup Requirements CAT5/5e Networking Cable. Mount the Unit on a Pole Prepare Unit to mount to a pole Page Configure the IP Address For Windows 95/98/98SE/ME/NT Page For Windows XP/2000 Page Access the Web Interface Access with uConfig Page Page A Page Navigation Main Menu Bar How to save changes. Basic Network Tab Network Modes: Bridging and Routing LAN Setup Page Basic Wireless Tab Enable the radio Basic Wireless Settings Wireless Mode Access Point Parameters Settings Channel Spectrum Width Channel Frequency Data Rate Rate Aggressiveness Station Parameters Settings Page Wireless Security WPA or WPA2 Authentication WPA PSK WPA + EAP WPA + EAP_TLS, WPA-TTLS, WP A-PEAP IEEE802.1x Settings WEP Authentication Type: Open Authentication (Default) No authentication. Recommend to use this standard option Shared Authentication Virtual Access Point (VAP) Advance Wireless Tab Long Range Parameters Setup Page Advanced Network Tab Spanning Tree Setup NAT Setup IP Forwarding: Bandwidth Control Firewall Setup Firewall Setup: Outbound Filtering Setup Filtering Setup: DNS Relay Setup: UPNP: Services T ab Ping Watchdog Auto-Reboot SNMP Setup NTP Setup Web HTTP Security Telnet Access Setup SSH Access Setup System Log Setup System T ab Firmware Upgrade Host Name Administrative and Read-only Account Default administrator login credentials: Enable Read-Only Account Configuration Management Device Maintenance Reboot: Reset to Defaults: Status Page Status Reporting LAN Setting Station Connection Status Info WLAN Connected Status: Page Appendix I - Network Network Mode Selections Network Mode: Bridge Mode Bridge Mode Network Settings Page Bridge mode Firewall Configuration Settings Appendix II Wireless with Router Mode AP-Router mode Network Settings IP Address Netmask: This is used to define the device IP classification for the chosen IP address range. Gateway IP: Enable NAT: Enable DHCP Server: Range Start/End: Port Forwarding Settings Bridge mode Firewall Configuration Settings Page Appendix III- Advanced Settings Advanced Wireless Setting Acknowledgement Timeout Signal Strength LED Settings Appendix IV- Services Ping WatchDog SNMP Agent NTP Client, Web, Telnet, SSH Server System Log